#define I2C_DELAY udelay(2)
+ CONFIG_SOFT_I2C_GPIO_SCL / CONFIG_SOFT_I2C_GPIO_SDA
+
+ If your arch supports the generic GPIO framework (asm/gpio.h),
+ then you may alternatively define the two GPIOs that are to be
+ used as SCL / SDA. Any of the previous I2C_xxx macros will
+ have GPIO-based defaults assigned to them as appropriate.
+
+ You should define these to the GPIO value as given directly to
+ the generic GPIO functions.
+
CONFIG_SYS_I2C_INIT_BOARD
When a board is reset during an i2c bus transfer
Please note that the environment is read-only until the monitor
has been relocated to RAM and a RAM copy of the environment has been
-created; also, when using EEPROM you will have to use getenv_r()
+created; also, when using EEPROM you will have to use getenv_f()
until then to read environment variables.
The environment is protected by a CRC32 checksum. Before the monitor
interface is currently active. For example you
can do the following
- => setenv ethact FEC ETHERNET
- => ping 192.168.0.1 # traffic sent on FEC ETHERNET
- => setenv ethact SCC ETHERNET
- => ping 10.0.0.1 # traffic sent on SCC ETHERNET
+ => setenv ethact FEC
+ => ping 192.168.0.1 # traffic sent on FEC
+ => setenv ethact SCC
+ => ping 10.0.0.1 # traffic sent on SCC
ethrotate - When set to "no" U-Boot does not go through all
available network interfaces.