- loads U-Boot or (in falcon mode) Linux
-
Configuration Options:
----------------------
crash. This is needed for buggy hardware (uc101) where
no pull down resistor is connected to the signal IDE5V_DD7.
- CONFIG_MACH_TYPE [relevant for ARM only][mandatory]
-
- This setting is mandatory for all boards that have only one
- machine type and must be used to specify the machine type
- number as it appears in the ARM machine registry
- (see https://www.arm.linux.org.uk/developer/machines/).
- Only boards that have multiple machine types supported
- in a single configuration file and the machine type is
- runtime discoverable, do not have to use this setting.
-
- vxWorks boot parameters:
bootvx constructs a valid bootline using the following
time on others. This setting #define's the initial
value of the "loads_echo" environment variable.
-- Kgdb Serial Baudrate: (if CONFIG_CMD_KGDB is defined)
- CONFIG_KGDB_BAUDRATE
- Select one of the baudrates listed in
- CONFIG_SYS_BAUDRATE_TABLE, see below.
-
- Removal of commands
If no commands are needed to boot, you can disable
CONFIG_CMDLINE to remove them. In this case, the command line
Support for National dp8382[01] gigabit chips.
- NETWORK Support (other):
-
- CONFIG_DRIVER_AT91EMAC
- Support for AT91RM9200 EMAC.
-
- CONFIG_RMII
- Define this to use reduced MII inteface
-
- CONFIG_DRIVER_AT91EMAC_QUIET
- If this defined, the driver is quiet.
- The driver doen't show link status messages.
-
CONFIG_CALXEDA_XGMAC
Support for the Calxeda XGMAC device
CONFIG_SYS_OR3_PRELIM, CONFIG_SYS_BR3_PRELIM:
Memory Controller Definitions: BR2/3 and OR2/3 (SDRAM)
-- CONFIG_PCI_INDIRECT_BRIDGE:
- Enable support for indirect PCI bridges.
-
- CONFIG_SYS_SRIO:
Chip has SRIO or not