CONFIG_CMD_DHCP * DHCP support
CONFIG_CMD_DIAG * Diagnostics
CONFIG_CMD_DOC * Disk-On-Chip Support
+ CONFIG_CMD_DS4510 * ds4510 I2C gpio commands
+ CONFIG_CMD_DS4510_INFO * ds4510 I2C info command
+ CONFIG_CMD_DS4510_MEM * ds4510 I2C eeprom/sram commansd
+ CONFIG_CMD_DS4510_RST * ds4510 I2C rst command
CONFIG_CMD_DTT * Digital Therm and Thermostat
CONFIG_CMD_ECHO echo arguments
CONFIG_CMD_EEPROM * EEPROM read/write support
Bus on the MPC8260. But it should be not so difficult
to add this option to other architectures.
+ CONFIG_SOFT_I2C_READ_REPEATED_START
+
+ defining this will force the i2c_read() function in
+ the soft_i2c driver to perform an I2C repeated start
+ between writing the address pointer and reading the
+ data. If this define is omitted the default behaviour
+ of doing a stop-start sequence will be used. Most I2C
+ devices can use either method, but some require one or
+ the other.
- SPI Support: CONFIG_SPI
- CONFIG_SYS_LONGHELP: Defined when you want long help messages included;
undefine this when you're short of memory.
+- CONFIG_SYS_HELP_CMD_WIDTH: Defined when you want to override the default
+ width of the commands listed in the 'help' command output.
+
- CONFIG_SYS_PROMPT: This is what U-Boot prints on the console to
prompt for user input.
locked as (mis-) used as memory, etc.
Chris Hallinan posted a good summary of these issues to the
- u-boot-users mailing list:
+ U-Boot mailing list:
Subject: RE: [U-Boot-Users] RE: More On Memory Bank x (nothingness)?
From: "Chris Hallinan" <clh@net1plus.com>
Download latest U-Boot source;
- Subscribe to u-boot-users mailing list;
+ Subscribe to u-boot mailing list;
if (clueless) {
email ("Hi, I am new to U-Boot, how do I get started?");
establish some rules. Submissions which do not conform to these rules
may be rejected, even when they contain important and valuable stuff.
-Patches shall be sent to the u-boot-users mailing list.
-
Please see http://www.denx.de/wiki/U-Boot/Patches for details.
+Patches shall be sent to the u-boot mailing list <u-boot@lists.denx.de>;
+see http://lists.denx.de/mailman/listinfo/u-boot
+
When you send a patch, please include the following information with
it:
disabled must not need more memory than the old code without your
modification.
-* Remember that there is a size limit of 40 kB per message on the
- u-boot-users mailing list. Bigger patches will be moderated. If
- they are reasonable and not bigger than 100 kB, they will be
- acknowledged. Even bigger patches should be avoided.
+* Remember that there is a size limit of 100 kB per message on the
+ u-boot mailing list. Bigger patches will be moderated. If they are
+ reasonable and not too big, they will be acknowledged. But patches
+ bigger than the size limit should be avoided.