dm: core: Swap parameters of ofnode_write_prop()

[platform/kernel/u-boot.git] / README

diff --git a/README b/README
index 623f359..6b6f722 100644 (file)
--- a/README
+++ b/README
@@ -396,12 +396,6 @@ The following options need to be configured:
                Board config to use DDR3L. It can be enabled for SoCs with
                DDR3L controllers.
 
-               CONFIG_SYS_FSL_IFC_BE
-               Defines the IFC controller register space as Big Endian
-
-               CONFIG_SYS_FSL_IFC_LE
-               Defines the IFC controller register space as Little Endian
-
                CONFIG_SYS_FSL_IFC_CLK_DIV
                Defines divider of platform clock(clock input to IFC controller).
 
@@ -419,11 +413,6 @@ The following options need to be configured:
                same as CONFIG_SYS_DDR_SDRAM_BASE for  all Power SoCs. But
                it could be different for ARM SoCs.
 
-               CONFIG_SYS_FSL_DDR_INTLV_256B
-               DDR controller interleaving on 256-byte. This is a special
-               interleaving mode, handled by Dickens for Freescale layerscape
-               SoCs with ARM core.
-
                CONFIG_SYS_FSL_DDR_MAIN_NUM_CTRLS
                Number of controllers used as main memory.
 
@@ -1728,38 +1717,10 @@ Configuration Settings:
                Enables allocating and saving a kernel copy of the bd_info in
                space between "bootm_low" and "bootm_low" + BOOTMAPSZ.
 
-- CONFIG_SYS_MAX_FLASH_SECT:
-               Max number of sectors on a Flash chip
-
-- CONFIG_SYS_FLASH_ERASE_TOUT:
-               Timeout for Flash erase operations (in ms)
-
-- CONFIG_SYS_FLASH_WRITE_TOUT:
-               Timeout for Flash write operations (in ms)
-
-- CONFIG_SYS_FLASH_LOCK_TOUT
-               Timeout for Flash set sector lock bit operation (in ms)
-
-- CONFIG_SYS_FLASH_UNLOCK_TOUT
-               Timeout for Flash clear lock bits operation (in ms)
-
 - CONFIG_SYS_FLASH_PROTECTION
                If defined, hardware flash sectors protection is used
                instead of U-Boot software protection.
 
-- CONFIG_SYS_DIRECT_FLASH_TFTP:
-
-               Enable TFTP transfers directly to flash memory;
-               without this option such a download has to be
-               performed in two steps: (1) download to RAM, and (2)
-               copy from RAM to flash.
-
-               The two-step approach is usually more reliable, since
-               you can check if the download worked before you erase
-               the flash, but in some situations (when system RAM is
-               too limited to allow for a temporary copy of the
-               downloaded image) this option may be very useful.
-
 - CONFIG_SYS_FLASH_CFI:
                Define if the flash driver uses extra elements in the
                common flash structure for storing flash geometry.
@@ -1780,12 +1741,6 @@ Configuration Settings:
                s29ws-n MirrorBit flash has non-standard addresses for buffered
                write commands.
 
-- CONFIG_SYS_FLASH_QUIET_TEST
-               If this option is defined, the common CFI flash doesn't
-               print it's warning upon not recognized FLASH banks. This
-               is useful, if some of the configured banks are only
-               optionally available.
-
 - CONFIG_FLASH_SHOW_PROGRESS
                If defined (must be an integer), print out countdown
                digits and dots.  Recommended value: 45 (9..1) for 80