- PWM Support:
CONFIG_PWM_IMX
- Support for PWM modul on the imx6.
+ Support for PWM module on the imx6.
- TPM Support:
CONFIG_TPM
additional defines:
CONFIG_SYS_NUM_I2C_BUSES
- Hold the number of i2c buses you want to use. If you
- don't use/have i2c muxes on your i2c bus, this
- is equal to CONFIG_SYS_NUM_I2C_ADAPTERS, and you can
- omit this define.
+ Hold the number of i2c buses you want to use.
CONFIG_SYS_I2C_DIRECT_BUS
define this, if you don't use i2c muxes on your hardware.
will skip addresses 0x50 and 0x68 on a board with one I2C bus
#define CONFIG_I2C_MULTI_BUS
- #define CONFIG_SYS_I2C_MULTI_NOPROBES {{0,0x50},{0,0x68},{1,0x54}}
+ #define CONFIG_SYS_I2C_NOPROBES {{0,0x50},{0,0x68},{1,0x54}}
will skip addresses 0x50 and 0x68 on bus 0 and address 0x54 on bus 1
CONFIG_SYS_GBL_DATA_OFFSET is chosen such that the initial
data is located at the end of the available space
(sometimes written as (CONFIG_SYS_INIT_RAM_SIZE -
- CONFIG_SYS_INIT_DATA_SIZE), and the initial stack is just
+ GENERATED_GBL_DATA_SIZE), and the initial stack is just
below that area (growing from (CONFIG_SYS_INIT_RAM_ADDR +
CONFIG_SYS_GBL_DATA_OFFSET) downward.
enable SPI microcode relocation patch (MPC8xx);
define relocation offset in DPRAM [SCC4]
-- CONFIG_SYS_USE_OSCCLK:
- Use OSCM clock mode on MBX8xx board. Be careful,
- wrong setting might damage your board. Read
- doc/README.MBX before setting this variable!
-
- CONFIG_SYS_CPM_POST_WORD_ADDR: (MPC8xx, MPC8260 only)
Offset of the bootmode word in DPRAM used by post
(Power On Self Tests). This definition overrides