* Adds the "fdt" command
* The bootm command automatically updates the fdt
- OF_CPU - The proper name of the cpus node (only required for
- MPC512X and MPC5xxx based boards).
- OF_SOC - The proper name of the soc node (only required for
- MPC512X and MPC5xxx based boards).
OF_TBCLK - The timebase frequency.
OF_STDOUT_PATH - The path to the console device
CONFIG_SCSI * SCSI Support
CONFIG_CMD_SDRAM * print SDRAM configuration information
(requires CONFIG_CMD_I2C)
- CONFIG_CMD_SETGETDCR Support for DCR Register access
- (4xx only)
CONFIG_CMD_SF * Read/write/erase SPI NOR flash
CONFIG_CMD_SOFTSWITCH * Soft switch setting command for BF60x
CONFIG_CMD_SOURCE "source" command Support
- USB Support:
At the moment only the UHCI host controller is
- supported (PIP405, MIP405, MPC5200); define
+ supported (PIP405, MIP405); define
CONFIG_USB_UHCI to enable it.
define CONFIG_USB_KEYBOARD to enable the USB Keyboard
and define CONFIG_USB_STORAGE to enable the USB
Note:
Supported are USB Keyboards and USB Floppy drives
(TEAC FD-05PUB).
- MPC5200 USB requires additional defines:
- CONFIG_USB_CLOCK
- for 528 MHz Clock: 0x0001bbbb
- CONFIG_PSC3_USB
- for USB on PSC3
- CONFIG_USB_CONFIG
- for differential drivers: 0x00001000
- for single ended drivers: 0x00005000
- for differential drivers on PSC3: 0x00000100
- for single ended drivers on PSC3: 0x00004100
- CONFIG_SYS_USB_EVENT_POLL
- May be defined to allow interrupt polling
- instead of using asynchronous interrupts
CONFIG_USB_EHCI_TXFIFO_THRESH enables setting of the
txfilltuning field in the EHCI controller on reset.
In such cases CONFIG_GPIO_LED_INVERTED_TABLE may be defined
with a list of GPIO LEDs that have inverted polarity.
-- CAN Support: CONFIG_CAN_DRIVER
-
- Defining CONFIG_CAN_DRIVER enables CAN driver support
- on those systems that support this (optional)
- feature.
-
- I2C Support: CONFIG_SYS_I2C
This enable the NEW i2c subsystem, and will allow you to use
Define this option to include a destructive SPI flash
test ('sf test').
- CONFIG_SF_DUAL_FLASH Dual flash memories
-
- Define this option to use dual flash support where two flash
- memories can be connected with a given cs line.
- Currently Xilinx Zynq qspi supports these type of connections.
-
- SystemACE Support:
CONFIG_SYSTEMACE
sequences.
U-Boot uses the following memory types:
- - PPC4xx: data cache
- CONFIG_SYS_GBL_DATA_OFFSET:
CONFIG_SYS_OR3_PRELIM, CONFIG_SYS_BR3_PRELIM:
Memory Controller Definitions: BR2/3 and OR2/3 (SDRAM)
-- CONFIG_PCI_DISABLE_PCIE:
- Disable PCI-Express on systems where it is supported but not
- required.
-
- CONFIG_PCI_ENUM_ONLY
Only scan through and get the devices on the buses.
Don't do any setup work, presumably because someone or