fsl_esdhc: Add the workaround for erratum ESDHC135 (enable on P4080)

[platform/kernel/u-boot.git] / README

diff --git a/README b/README
index 1acf9a3..556bf59 100644 (file)
--- a/README
+++ b/README
@@ -861,6 +861,18 @@ The following options need to be configured:
                        Define this to use i/o functions instead of macros
                        (some hardware wont work with macros)
 
+               CONFIG_FTGMAC100
+               Support for Faraday's FTGMAC100 Gigabit SoC Ethernet
+
+                       CONFIG_FTGMAC100_EGIGA
+                       Define this to use GE link update with gigabit PHY.
+                       Define this if FTGMAC100 is connected to gigabit PHY.
+                       If your system has 10/100 PHY only, it might not occur
+                       wrong behavior. Because PHY usually return timeout or
+                       useless data when polling gigabit status and gigabit
+                       control registers. This behavior won't affect the
+                       correctnessof 10/100 link speed update.
+
                CONFIG_SMC911X
                Support for SMSC's LAN911x and LAN921x chips
 
@@ -2771,6 +2783,24 @@ Low Level (hardware related) configuration options:
                Disable PCI-Express on systems where it is supported but not
                required.
 
+- CONFIG_SYS_SRIO:
+               Chip has SRIO or not
+
+- CONFIG_SRIO1:
+               Board has SRIO 1 port available
+
+- CONFIG_SRIO2:
+               Board has SRIO 2 port available
+
+- CONFIG_SYS_SRIOn_MEM_VIRT:
+               Virtual Address of SRIO port 'n' memory region
+
+- CONFIG_SYS_SRIOn_MEM_PHYS:
+               Physical Address of SRIO port 'n' memory region
+
+- CONFIG_SYS_SRIOn_MEM_SIZE:
+               Size of SRIO port 'n' memory region
+
 - CONFIG_SPD_EEPROM
                Get DDR timing information from an I2C EEPROM. Common
                with pluggable memory modules such as SODIMMs
@@ -2836,15 +2866,15 @@ Low Level (hardware related) configuration options:
                globally (CONFIG_CMD_MEM).
 
 - CONFIG_SKIP_LOWLEVEL_INIT
-                [ARM only] If this variable is defined, then certain
-                low level initializations (like setting up the memory
-                controller) are omitted and/or U-Boot does not
-                relocate itself into RAM.
-
-                Normally this variable MUST NOT be defined. The only
-                exception is when U-Boot is loaded (to RAM) by some
-                other boot loader or by a debugger which performs
-                these initializations itself.
+               [ARM only] If this variable is defined, then certain
+               low level initializations (like setting up the memory
+               controller) are omitted and/or U-Boot does not
+               relocate itself into RAM.
+
+               Normally this variable MUST NOT be defined. The only
+               exception is when U-Boot is loaded (to RAM) by some
+               other boot loader or by a debugger which performs
+               these initializations itself.
 
 - CONFIG_PRELOADER
                Modifies the behaviour of start.S when compiling a loader