If defined, then this indicates the I2C bus number for the DTT.
If not defined, then U-Boot assumes that DTT is on I2C bus 0.
+ CFG_I2C_DTT_ADDR:
+
+ If defined, specifies the I2C address of the DTT device.
+ If not defined, then U-Boot uses predefined value for
+ specified DTT device.
+
CONFIG_FSL_I2C
Define this option if you want to use Freescale's I2C driver in
* Target Operating System (Provisions for OpenBSD, NetBSD, FreeBSD,
4.4BSD, Linux, SVR4, Esix, Solaris, Irix, SCO, Dell, NCR, VxWorks,
- LynxOS, pSOS, QNX, RTEMS;
- Currently supported: Linux, NetBSD, VxWorks, QNX, RTEMS, LynxOS).
+ LynxOS, pSOS, QNX, RTEMS, INTEGRITY;
+ Currently supported: Linux, NetBSD, VxWorks, QNX, RTEMS, LynxOS,
+ INTEGRITY).
* Target CPU Architecture (Provisions for Alpha, ARM, AVR32, Intel x86,
IA64, MIPS, NIOS, PowerPC, IBM S390, SuperH, Sparc, Sparc 64 Bit;
Currently supported: ARM, AVR32, Intel x86, MIPS, NIOS, PowerPC).