bk4r1: Re-convert CONFIG_AUTOBOOT_PROMPT et al to Kconfig

[platform/kernel/u-boot.git] / README

diff --git a/README b/README
index 17dc0ee..4367ac3 100644 (file)
--- a/README
+++ b/README
@@ -889,11 +889,6 @@ The following options need to be configured:
                Allow generic access to the SPI bus on the Intel 8257x, for
                example with the "sspi" command.
 
-               CONFIG_EEPRO100
-               Support for Intel 82557/82559/82559ER chips.
-               Optional CONFIG_EEPRO100_SROM_WRITE enables EEPROM
-               write routine for first time initialisation.
-
                CONFIG_TULIP
                Support for Digital 2114x chips.
 
@@ -1330,21 +1325,6 @@ The following options need to be configured:
                can be displayed via the splashscreen support or the
                bmp command.
 
-- Compression support:
-               CONFIG_GZIP
-
-               Enabled by default to support gzip compressed images.
-
-               CONFIG_BZIP2
-
-               If this option is set, support for bzip2 compressed
-               images is included. If not, only uncompressed and gzip
-               compressed images are supported.
-
-               NOTE: the bzip2 algorithm requires a lot of RAM, so
-               the malloc area (as defined by CONFIG_SYS_MALLOC_LEN) should
-               be at least 4MB.
-
 - MII/PHY support:
                CONFIG_PHY_CLOCK_FREQ (ppc4xx)
 
@@ -1567,14 +1547,6 @@ The following options need to be configured:
 
                This enable the NEW i2c subsystem, and will allow you to use
                i2c commands at the u-boot command line (as long as you set
-               CONFIG_CMD_I2C in CONFIG_COMMANDS) and communicate with i2c
-               based realtime clock chips or other i2c devices. See
-               common/cmd_i2c.c for a description of the command line
-               interface.
-
-               ported i2c driver to the new framework:
-               - drivers/i2c/soft_i2c.c:
-                 - activate first bus with CONFIG_SYS_I2C_SOFT define
                    CONFIG_SYS_I2C_SOFT_SPEED and CONFIG_SYS_I2C_SOFT_SLAVE
                    for defining speed and slave address
                  - activate second bus with I2C_SOFT_DECLARATIONS2 define