CONFIG_SYS_FSL_DSP_CCSRBAR_DEFAULT
This value denotes start offset of DSP CCSR space.
+ CONFIG_SYS_FSL_SINGLE_SOURCE_CLK
+ Single Source Clock is clocking mode present in some of FSL SoC's.
+ In this mode, a single differential clock is used to supply
+ clocks to the sysclock, ddrclock and usbclock.
+
- Generic CPU options:
CONFIG_SYS_BIG_ENDIAN, CONFIG_SYS_LITTLE_ENDIAN
Board config to use DDR3. It can be enabled for SoCs with
Freescale DDR3 controllers.
+ CONFIG_SYS_FSL_PBL_PBI
+ It enables addition of RCW (Power on reset configuration) in built image.
+ Please refer doc/README.pblimage for more details
+
+ CONFIG_SYS_FSL_PBL_RCW
+ It adds PBI(pre-boot instructions) commands in u-boot build image.
+ PBI commands can be used to configure SoC before it starts the execution.
+ Please refer doc/README.pblimage for more details
+
- Intel Monahans options:
CONFIG_SYS_MONAHANS_RUN_MODE_OSC_RATIO
Define this option to use the Bank addr/Extended addr
support on SPI flashes which has size > 16Mbytes.
+ CONFIG_SF_DUAL_FLASH Dual flash memories
+
+ Define this option to use dual flash support where two flash
+ memories can be connected with a given cs line.
+ currently Xilinx Zynq qspi support these type of connections.
+
- SystemACE Support:
CONFIG_SYSTEMACE
Defines the size and behavior of the NAND that SPL uses
to read U-Boot
+ CONFIG_SPL_NAND_BOOT
+ Add support NAND boot
+
CONFIG_SYS_NAND_U_BOOT_OFFS
Location in NAND to read U-Boot from
Load Address: 0x00000000
Entry Point: 0x00000000
+The "dumpimage" is a tool to disassemble images built by mkimage. Its "-i"
+option performs the converse operation of the mkimage's second form (the "-d"
+option). Given an image built by mkimage, the dumpimage extracts a "data file"
+from the image:
+
+ tools/dumpimage -i image -p position data_file
+ -i ==> extract from the 'image' a specific 'data_file', \
+ indexed by 'position'
+
Installing a Linux Image:
-------------------------