[PATCH] Fix problem in systemace driver (ace_writew instead of ace_write)

[platform/kernel/u-boot.git] / README

diff --git a/README b/README
index 6b94f84..1542864 100644 (file)
--- a/README
+++ b/README
@@ -1342,6 +1342,27 @@ The following options need to be configured:
 
                will skip addresses 0x50 and 0x68 on bus 0 and address 0x54 on bus 1
 
+               CFG_SPD_BUS_NUM
+
+               If defined, then this indicates the I2C bus number for DDR SPD.
+               If not defined, then U-Boot assumes that SPD is on I2C bus 0.
+
+               CFG_RTC_BUS_NUM
+
+               If defined, then this indicates the I2C bus number for the RTC.
+               If not defined, then U-Boot assumes that RTC is on I2C bus 0.
+
+               CFG_DTT_BUS_NUM
+
+               If defined, then this indicates the I2C bus number for the DTT.
+               If not defined, then U-Boot assumes that DTT is on I2C bus 0.
+
+               CONFIG_FSL_I2C
+
+               Define this option if you want to use Freescale's I2C driver in
+               drivers/fsl_i2c.c.
+
+
 - SPI Support: CONFIG_SPI
 
                Enables SPI driver (so far only tested with
@@ -1500,8 +1521,8 @@ The following options need to be configured:
 
                Enable auto completion of commands using TAB.
 
-                Note that this feature has NOT been implemented yet
-                for the "hush" shell.
+               Note that this feature has NOT been implemented yet
+               for the "hush" shell.
 
 
                CFG_HUSH_PARSER
@@ -2249,6 +2270,14 @@ Low Level (hardware related) configuration options:
                If SPD EEPROM is on an I2C bus other than the first one, specify here.
                Note that the value must resolve to something your driver can deal with.
 
+- CFG_83XX_DDR_USES_CS0
+               Only for 83xx systems. If specified, then DDR should be configured
+               using CS0 and CS1 instead of CS2 and CS3.
+
+- CFG_83XX_DDR_USES_CS0
+               Only for 83xx systems. If specified, then DDR should be configured
+               using CS0 and CS1 instead of CS2 and CS3.
+
 - CONFIG_ETHER_ON_FEC[12]
                Define to enable FEC[12] on a 8xx series processor.
 
@@ -3154,11 +3183,11 @@ loadaddr=200000
 oftaddr=0x300000
 => bootm $loadaddr - $oftaddr
 ## Booting image at 00200000 ...
-   Image Name:   Linux-2.6.17-dirty
-   Image Type:   PowerPC Linux Kernel Image (gzip compressed)
-   Data Size:    1029343 Bytes = 1005.2 kB
+   Image Name:  Linux-2.6.17-dirty
+   Image Type:  PowerPC Linux Kernel Image (gzip compressed)
+   Data Size:   1029343 Bytes = 1005.2 kB
    Load Address: 00000000
-   Entry Point:  00000000
+   Entry Point:         00000000
    Verifying Checksum ... OK
    Uncompressing Kernel Image ... OK
 Booting using flat device tree at 0x300000