default y if TFABOOT
help
Typically, we use an initial stack pointer address that is calculated
- by taking the statically defined CONFIG_SYS_INIT_RAM_ADDR, adding the
- statically defined CONFIG_SYS_INIT_RAM_SIZE and then subtracting the
+ by taking the statically defined CFG_SYS_INIT_RAM_ADDR, adding the
+ statically defined CFG_SYS_INIT_RAM_SIZE and then subtracting the
build-time constant of GENERATED_GBL_DATA_SIZE. On MIPS a different
but statica calculation is performed. However, some platforms will
take a different approach. Say Y here to define the address statically
particular needs this to operate, so that it can allocate the
initial serial device and any others that are needed.
- It is possible to enable CONFIG_SYS_SPL_MALLOC_START to start a new
+ It is possible to enable CFG_SYS_SPL_MALLOC_START to start a new
malloc() region in SDRAM once it is inited.
config TPL_SYS_MALLOC_F_LEN
default 0x10000 if TARGET_TRICORDER
default 0x0
+config SYS_MONITOR_LEN
+ int "Maximum size in bytes reserved for U-Boot in memory"
+ default 1048576 if X86
+ default 0
+ help
+ Size of memory reserved for monitor code, used to determine
+ _at_compile_time_ (!) if the environment is embedded within the
+ U-Boot image, or in a separate flash sector, among other uses where
+ we need to set a maximum size of the U-Boot binary itself that will
+ be loaded.
+
config MP
bool "Support for multiprocessor"
help