is selected automatically. Check
Documentation/kdump/kdump.txt for further details.
+ crashkernel_low=size[KMG]
+ [KNL, x86] parts under 4G.
+
crashkernel=range1:size1[,range2:size2,...][@offset]
[KNL] Same as above, but depends on the memory
in the running system. The syntax of range is
Claim all unknown PCI IDE storage controllers.
idle= [X86]
- Format: idle=poll, idle=mwait, idle=halt, idle=nomwait
+ Format: idle=poll, idle=halt, idle=nomwait
Poll forces a polling idle loop that can slightly
improve the performance of waking up a idle CPU, but
will use a lot of power and make the system run hot.
Not recommended.
- idle=mwait: On systems which support MONITOR/MWAIT but
- the kernel chose to not use it because it doesn't save
- as much power as a normal idle loop, use the
- MONITOR/MWAIT idle loop anyways. Performance should be
- the same as idle=poll.
idle=halt: Halt is forced to be used for CPU idle.
In such case C2/C3 won't be used again.
idle=nomwait: Disable mwait for CPU C-states
0 disables intel_idle and fall back on acpi_idle.
1 to 6 specify maximum depth of C-state.
+ intel_pstate= [X86]
+ disable
+ Do not enable intel_pstate as the default
+ scaling driver for the supported processors
+
intremap= [X86-64, Intel-IOMMU]
on enable Interrupt Remapping (default)
off disable Interrupt Remapping
that the amount of memory usable for all allocations
is not too small.
+ movablemem_map=nn[KMG]@ss[KMG]
+ [KNL,X86,IA-64,PPC] This parameter is similar to
+ memmap except it specifies the memory map of
+ ZONE_MOVABLE.
+ If more areas are all within one node, then from
+ lowest ss to the end of the node will be ZONE_MOVABLE.
+ If an area covers two or more nodes, the area from
+ ss to the end of the 1st node will be ZONE_MOVABLE,
+ and all the rest nodes will only have ZONE_MOVABLE.
+ If memmap is specified at the same time, the
+ movablemem_map will be limited within the memmap
+ areas. If kernelcore or movablecore is also specified,
+ movablemem_map will have higher priority to be
+ satisfied. So the administrator should be careful that
+ the amount of movablemem_map areas are not too large.
+ Otherwise kernel won't have enough memory to start.
+
MTD_Partition= [MTD]
Format: <name>,<region-number>,<size>,<offset>
wfi(ARM) instruction doesn't work correctly and not to
use it. This is also useful when using JTAG debugger.
- no-hlt [BUGS=X86-32] Tells the kernel that the hlt
- instruction doesn't work correctly and not to
- use it.
-
no_file_caps Tells the kernel not to honor file capabilities. The
only way then for a file to be executed with privilege
is to be setuid root or executed by root.