Merge tag 'devicetree-for-5.7' of git://git.kernel.org/pub/scm/linux/kernel/git/robh...

[platform/kernel/linux-starfive.git] / Documentation / devicetree / bindings / serial / fsl-imx-uart.txt

diff --git a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
index 556ad11..9582fc2 100644 (file)
--- a/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
+++ b/Documentation/devicetree/bindings/serial/fsl-imx-uart.txt
@@ -8,6 +8,10 @@ Required properties:
 Optional properties:
 - fsl,dte-mode : Indicate the uart works in DTE mode. The uart works
                   in DCE mode by default.
+- fsl,inverted-tx , fsl,inverted-rx : Indicate that the hardware attached
+  to the peripheral inverts the signal transmitted or received,
+  respectively, and that the peripheral should invert its output/input
+  using the INVT/INVR registers.
 - rs485-rts-delay, rs485-rts-active-low, rs485-rx-during-tx,
   linux,rs485-enabled-at-boot-time: see rs485.txt. Note that for RS485
   you must enable either the "uart-has-rtscts" or the "rts-gpios"