-The low speed I/O connector supported as per table below.
-This assumes default BIOS settings, as they are not dynamcially detected
-If any changes are mode (Device Manager -> System Setup -> South Cluster -> LPSS & CSS)
-them mraa calls will not behave as expected.
-
-Documentation shows i2c on bus #5, ACPI shows it on bus #6, but driver uses bus #7.
+The low speed I/O connector supported as per table below. This assumes default
+BIOS settings, as they are not dynamcially detected If any changes are mode
+(Device Manager -> System Setup -> South Cluster -> LPSS & CSS) them mraa calls
+will not behave as expected.