+
+config CMD_FS_UUID
+ bool "fsuuid command"
+ help
+ Enables fsuuid command for filesystem UUID.
+
+config CMD_JFFS2
+ bool "jffs2 command"
+ select FS_JFFS2
+ help
+ Enables commands to support the JFFS2 (Journalling Flash File System
+ version 2) filesystem. This enables fsload, ls and fsinfo which
+ provide the ability to load files, list directories and obtain
+ filesystem information.
+
+config CMD_MTDPARTS
+ bool "MTD partition support"
+ help
+ MTD partition support
+
+config MTDIDS_DEFAULT
+ string "Default MTD IDs"
+ depends on CMD_MTDPARTS
+ help
+ Defines a default MTD ID
+
+config MTDPARTS_DEFAULT
+ string "Default MTD partition scheme"
+ depends on CMD_MTDPARTS
+ help
+ Defines a default MTD partitioning scheme in the Linux MTD command
+ line partitions format
+
+config CMD_MTDPARTS_SPREAD
+ bool "Padd partition size to take account of bad blocks"
+ depends on CMD_MTDPARTS
+ help
+ This enables the 'spread' sub-command of the mtdparts command.
+ This command will modify the existing mtdparts variable by increasing
+ the size of the partitions such that 1) each partition's net size is
+ at least as large as the size specified in the mtdparts variable and
+ 2) each partition starts on a good block.
+
+config CMD_REISER
+ bool "reiser - Access to reiserfs filesystems"
+ help
+ This provides two commands which operate on a resierfs filesystem,
+ commonly used some years ago:
+
+ reiserls - list files
+ reiserload - load a file
+
+config CMD_SCSI
+ bool "scsi - Access to SCSI devices"
+ default y if SCSI
+ help
+ This provides a 'scsi' command which provides access to SCSI (Small
+ Computer System Interface) devices. The command provides a way to
+ scan the bus, reset the bus, read and write data and get information
+ about devices.
+
+endmenu
+
+menu "Debug commands"
+
+config CMD_BEDBUG
+ bool "bedbug"
+ help
+ The bedbug (emBEDded deBUGger) command provides debugging features
+ for some PowerPC processors. For details please see the
+ docuemntation in doc/README.beddbug
+
+config CMD_DIAG
+ bool "diag - Board diagnostics"
+ help
+ This command provides access to board diagnostic tests. These are
+ called Power-on Self Tests (POST). The command allows listing of
+ available tests and running either all the tests, or specific tests
+ identified by name.
+
+config CMD_IRQ
+ bool "irq - Show information about interrupts"
+ depends on !ARM && !MIPS && !SH
+ help
+ This enables two commands:
+
+ interrupts - enable or disable interrupts
+ irqinfo - print device-specific interrupt information
+
+config CMD_KGDB
+ bool "kgdb - Allow debugging of U-Boot with gdb"
+ help
+ This enables a 'kgdb' command which allows gdb to connect to U-Boot
+ over a serial link for debugging purposes. This allows
+ single-stepping, inspecting variables, etc. This is supported only
+ on PowerPC at present.
+