+#if defined(CONFIG_MGCOGE3UN)
+
+#define PHY_LED_SEL 0x18
+#define PHY_LED0_LINK (0x5)
+#define PHY_LED1_ACT (0x8<<4)
+#define PHY_LED2_INT (0xe<<8)
+#define PHY_SPEC_CTRL 0x1c
+#define PHY_RGMII_CLK_STABLE (0x1<<10)
+#define PHY_CLSA (0x1<<1)
+
+/* Configure and enable MV88E3018 PHY */
+void reset_phy(void)
+{
+ char *name = "egiga0";
+ unsigned short reg;
+
+ if (miiphy_set_current_dev(name))
+ return;
+
+ /* RGMII clk transition on data stable */
+ if (miiphy_read(name, CONFIG_PHY_BASE_ADR, PHY_SPEC_CTRL, ®) != 0)
+ printf("Error reading PHY spec ctrl reg\n");
+ if (miiphy_write(name, CONFIG_PHY_BASE_ADR, PHY_SPEC_CTRL,
+ reg | PHY_RGMII_CLK_STABLE | PHY_CLSA) != 0)
+ printf("Error writing PHY spec ctrl reg\n");
+
+ /* leds setup */
+ if (miiphy_write(name, CONFIG_PHY_BASE_ADR, PHY_LED_SEL,
+ PHY_LED0_LINK | PHY_LED1_ACT | PHY_LED2_INT) != 0)
+ printf("Error writing PHY LED reg\n");
+
+ /* reset the phy */
+ miiphy_reset(name, CONFIG_PHY_BASE_ADR);
+}
+#else
+/* Configure and enable MV88E1118 PHY on the piggy*/