projects
/
platform
/
kernel
/
u-boot.git
/ blobdiff
commit
grep
author
committer
pickaxe
?
search:
re
summary
|
shortlog
|
log
|
commit
|
commitdiff
|
tree
raw
|
inline
| side by side
Remove "atmel_df_pow2" binary with "make clean"
[platform/kernel/u-boot.git]
/
README
diff --git
a/README
b/README
index
cf3867d
..
ff4ed8b
100644
(file)
--- a/
README
+++ b/
README
@@
-858,9
+858,13
@@
The following options need to be configured:
MPC5200 USB requires additional defines:
CONFIG_USB_CLOCK
for 528 MHz Clock: 0x0001bbbb
MPC5200 USB requires additional defines:
CONFIG_USB_CLOCK
for 528 MHz Clock: 0x0001bbbb
+ CONFIG_PSC3_USB
+ for USB on PSC3
CONFIG_USB_CONFIG
for differential drivers: 0x00001000
for single ended drivers: 0x00005000
CONFIG_USB_CONFIG
for differential drivers: 0x00001000
for single ended drivers: 0x00005000
+ for differential drivers on PSC3: 0x00000100
+ for single ended drivers on PSC3: 0x00004100
CONFIG_SYS_USB_EVENT_POLL
May be defined to allow interrupt polling
instead of using asynchronous interrupts
CONFIG_SYS_USB_EVENT_POLL
May be defined to allow interrupt polling
instead of using asynchronous interrupts
@@
-1362,6
+1366,13
@@
The following options need to be configured:
therefore be cleared to 0 (See, eg, MPC823e User's Manual
p.16-473). So, set CONFIG_SYS_I2C_SLAVE to 0.
therefore be cleared to 0 (See, eg, MPC823e User's Manual
p.16-473). So, set CONFIG_SYS_I2C_SLAVE to 0.
+ CONFIG_SYS_I2C_INIT_MPC5XXX
+
+ When a board is reset during an i2c bus transfer
+ chips might think that the current transfer is still
+ in progress. Reset the slave devices by sending start
+ commands until the slave device responds.
+
That's all that's required for CONFIG_HARD_I2C.
If you use the software i2c interface (CONFIG_SOFT_I2C)
That's all that's required for CONFIG_HARD_I2C.
If you use the software i2c interface (CONFIG_SOFT_I2C)
@@
-3908,10
+3919,10
@@
For PowerPC, the following registers have specific use:
average for all boards 752 bytes for the whole U-Boot image,
624 text + 127 data).
average for all boards 752 bytes for the whole U-Boot image,
624 text + 127 data).
-On Blackfin, the normal C ABI (except for P
5
) is followed as documented here:
+On Blackfin, the normal C ABI (except for P
3
) is followed as documented here:
http://docs.blackfin.uclinux.org/doku.php?id=application_binary_interface
http://docs.blackfin.uclinux.org/doku.php?id=application_binary_interface
- ==> U-Boot will use P
5
to hold a pointer to the global data
+ ==> U-Boot will use P
3
to hold a pointer to the global data
On ARM, the following registers are used:
On ARM, the following registers are used: