Convert CONFIG_SPLASH_SCREEN et al to Kconfig

[platform/kernel/u-boot.git] / README

diff --git a/README b/README
index 121dc49..6cb0567 100644 (file)
--- a/README
+++ b/README
@@ -1250,48 +1250,6 @@ The following options need to be configured:
                Enables an 'i2c edid' command which can read EDID
                information over I2C from an attached LCD display.
 
                Enables an 'i2c edid' command which can read EDID
                information over I2C from an attached LCD display.
 

-- Splash Screen Support: CONFIG_SPLASH_SCREEN
-
-               If this option is set, the environment is checked for
-               a variable "splashimage". If found, the usual display
-               of logo, copyright and system information on the LCD
-               is suppressed and the BMP image at the address
-               specified in "splashimage" is loaded instead. The
-               console is redirected to the "nulldev", too. This
-               allows for a "silent" boot where a splash screen is
-               loaded very quickly after power-on.
-
-               CONFIG_SPLASHIMAGE_GUARD
-
-               If this option is set, then U-Boot will prevent the environment
-               variable "splashimage" from being set to a problematic address
-               (see doc/README.displaying-bmps).
-               This option is useful for targets where, due to alignment
-               restrictions, an improperly aligned BMP image will cause a data
-               abort. If you think you will not have problems with unaligned
-               accesses (for example because your toolchain prevents them)
-               there is no need to set this option.
-
-               CONFIG_SPLASH_SCREEN_ALIGN
-
-               If this option is set the splash image can be freely positioned
-               on the screen. Environment variable "splashpos" specifies the
-               position as "x,y". If a positive number is given it is used as
-               number of pixel from left/top. If a negative number is given it
-               is used as number of pixel from right/bottom. You can also
-               specify 'm' for centering the image.
-
-               Example:
-               setenv splashpos m,m
-                       => image at center of screen
-
-               setenv splashpos 30,20
-                       => image at x = 30 and y = 20
-
-               setenv splashpos -10,m
-                       => vertically centered image
-                          at x = dspWidth - bmpWidth - 9
-

 - Gzip compressed BMP image support: CONFIG_VIDEO_BMP_GZIP
 
                If this option is set, additionally to standard BMP
 - Gzip compressed BMP image support: CONFIG_VIDEO_BMP_GZIP
 
                If this option is set, additionally to standard BMP