bk4r1: Re-convert CONFIG_AUTOBOOT_PROMPT et al to Kconfig

[platform/kernel/u-boot.git] / README

diff --git a/README b/README
index 17dc0ee..4367ac3 100644 (file)
--- a/README
+++ b/README
@@ -889,11 +889,6 @@ The following options need to be configured:
                Allow generic access to the SPI bus on the Intel 8257x, for
                example with the "sspi" command.
 
                Allow generic access to the SPI bus on the Intel 8257x, for
                example with the "sspi" command.
 

-               CONFIG_EEPRO100
-               Support for Intel 82557/82559/82559ER chips.
-               Optional CONFIG_EEPRO100_SROM_WRITE enables EEPROM
-               write routine for first time initialisation.
-

                CONFIG_TULIP
                Support for Digital 2114x chips.
 
                CONFIG_TULIP
                Support for Digital 2114x chips.
 


@@ -1330,21 +1325,6 @@ The following options need to be configured:
                can be displayed via the splashscreen support or the
                bmp command.
 
                can be displayed via the splashscreen support or the
                bmp command.
 

-- Compression support:
-               CONFIG_GZIP
-
-               Enabled by default to support gzip compressed images.
-
-               CONFIG_BZIP2
-
-               If this option is set, support for bzip2 compressed
-               images is included. If not, only uncompressed and gzip
-               compressed images are supported.
-
-               NOTE: the bzip2 algorithm requires a lot of RAM, so
-               the malloc area (as defined by CONFIG_SYS_MALLOC_LEN) should
-               be at least 4MB.
-

 - MII/PHY support:
                CONFIG_PHY_CLOCK_FREQ (ppc4xx)
 
 - MII/PHY support:
                CONFIG_PHY_CLOCK_FREQ (ppc4xx)
 


@@ -1567,14 +1547,6 @@ The following options need to be configured:
 
                This enable the NEW i2c subsystem, and will allow you to use
                i2c commands at the u-boot command line (as long as you set
 
                This enable the NEW i2c subsystem, and will allow you to use
                i2c commands at the u-boot command line (as long as you set

-               CONFIG_CMD_I2C in CONFIG_COMMANDS) and communicate with i2c
-               based realtime clock chips or other i2c devices. See
-               common/cmd_i2c.c for a description of the command line
-               interface.
-
-               ported i2c driver to the new framework:
-               - drivers/i2c/soft_i2c.c:
-                 - activate first bus with CONFIG_SYS_I2C_SOFT define

                    CONFIG_SYS_I2C_SOFT_SPEED and CONFIG_SYS_I2C_SOFT_SLAVE
                    for defining speed and slave address
                  - activate second bus with I2C_SOFT_DECLARATIONS2 define
                    CONFIG_SYS_I2C_SOFT_SPEED and CONFIG_SYS_I2C_SOFT_SLAVE
                    for defining speed and slave address
                  - activate second bus with I2C_SOFT_DECLARATIONS2 define