1 # For more options and information see
2 # http://rpf.io/configtxt
3 # Some settings may impact device functionality. See link above for details
5 # uncomment if you get no picture on HDMI for a default "safe" mode
8 # uncomment this if your display has a black border of unused pixels visible
9 # and your display can output without overscan
12 # uncomment the following to adjust overscan. Use positive numbers if console
13 # goes off screen, and negative if there is too much border
19 # uncomment to force a console size. By default it will be display's size minus
21 #framebuffer_width=1280
22 #framebuffer_height=720
24 # uncomment if hdmi display is not detected and composite is being output
27 # uncomment to force a specific HDMI mode (this will force VGA)
31 # uncomment to force a HDMI mode rather than DVI. This can make audio work in
32 # DMT (computer monitor) modes
35 # uncomment to increase signal to HDMI, if you have interference, blanking, or
39 # uncomment for composite PAL
42 #uncomment to overclock the arm. 700 MHz is the default.
45 # Uncomment some or all of these to enable the optional hardware interfaces
50 # Uncomment this to enable the lirc-rpi module
53 # Additional overlays and parameters are documented /boot/overlays/README
55 # Enable audio (loads snd_bcm2835)
62 # Bit 9 of arm_control determines if arm is booted in 32-bit mode or 64-bit mode
63 arm_control=0x0 # for 32-bit
64 #arm_control=0x200 # for 64-bit
73 #disable_commandline_tags=1
78 # Enable the camera module
81 # Turn off the red camera LED when recording video or taking a still picture
84 # Minimum GPU memory for camera use
87 # Set gpio pins to Input, Pullup mode.
88 gpio=6,12,13,16,25=ip,pu