verdin-imx8mm, verdin-imx8mp: Fix default systemd console output
[platform/kernel/u-boot.git] / include / configs / verdin-imx8mm.h
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * Copyright 2020-2021 Toradex
4  */
5
6 #ifndef __VERDIN_IMX8MM_H
7 #define __VERDIN_IMX8MM_H
8
9 #include <asm/arch/imx-regs.h>
10 #include <linux/sizes.h>
11
12 #define CONFIG_SPL_MAX_SIZE             (148 * 1024)
13 #define CONFIG_SYS_MONITOR_LEN          SZ_512K
14 #define CONFIG_SYS_UBOOT_BASE   \
15         (QSPI0_AMBA_BASE + CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR * 512)
16
17 #define CONFIG_SYS_BOOTM_LEN           SZ_64M
18
19 #ifdef CONFIG_SPL_BUILD
20 #define CONFIG_SPL_STACK                0x920000
21 #define CONFIG_SPL_BSS_START_ADDR       0x910000
22 #define CONFIG_SPL_BSS_MAX_SIZE         SZ_8K   /* 8 KB */
23 #define CONFIG_SYS_SPL_MALLOC_START     0x42200000
24 #define CONFIG_SYS_SPL_MALLOC_SIZE      SZ_512K /* 512 KB */
25
26 /* malloc f used before GD_FLG_FULL_MALLOC_INIT set */
27 #define CONFIG_MALLOC_F_ADDR            0x930000
28 /* For RAW image gives a error info not panic */
29 #define CONFIG_SPL_ABORT_ON_RAW_IMAGE
30 #endif
31
32 #define MEM_LAYOUT_ENV_SETTINGS \
33         "fdt_addr_r=0x44000000\0" \
34         "kernel_addr_r=0x42000000\0" \
35         "ramdisk_addr_r=0x46400000\0" \
36         "scriptaddr=0x46000000\0"
37
38 /* Enable Distro Boot */
39 #ifndef CONFIG_SPL_BUILD
40 #define BOOT_TARGET_DEVICES(func) \
41         func(MMC, mmc, 1) \
42         func(MMC, mmc, 0) \
43         func(DHCP, dhcp, na)
44 #include <config_distro_bootcmd.h>
45 #else
46 #define BOOTENV
47 #endif
48
49 /* Initial environment variables */
50 #define CONFIG_EXTRA_ENV_SETTINGS \
51         BOOTENV \
52         MEM_LAYOUT_ENV_SETTINGS \
53         "bootcmd_mfg=fastboot 0\0" \
54         "boot_file=Image\0" \
55         "boot_script_dhcp=boot.scr\0" \
56         "console=ttymxc0\0" \
57         "fdt_addr=0x43000000\0" \
58         "fdt_board=dev\0" \
59         "initrd_addr=0x43800000\0" \
60         "initrd_high=0xffffffffffffffff\0" \
61         "setup=setenv setupargs console=tty1 console=${console},${baudrate} " \
62                 "consoleblank=0 earlycon\0" \
63         "update_uboot=askenv confirm Did you load flash.bin (y/N)?; " \
64                 "if test \"$confirm\" = \"y\"; then " \
65                 "setexpr blkcnt ${filesize} + 0x1ff && setexpr blkcnt " \
66                 "${blkcnt} / 0x200; mmc dev 0 1; mmc write ${loadaddr} 0x2 " \
67                 "${blkcnt}; fi\0"
68
69 #define CONFIG_SYS_INIT_RAM_ADDR        0x40000000
70 #define CONFIG_SYS_INIT_RAM_SIZE        SZ_2M
71 #define CONFIG_SYS_INIT_SP_OFFSET \
72         (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
73 #define CONFIG_SYS_INIT_SP_ADDR \
74         (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
75
76 #if defined(CONFIG_ENV_IS_IN_MMC)
77 /* Environment in eMMC, before config block at the end of 1st "boot sector" */
78 #endif
79
80 #define CONFIG_SYS_SDRAM_BASE           0x40000000
81
82 /* SDRAM configuration */
83 #define PHYS_SDRAM                      0x40000000
84 #define PHYS_SDRAM_SIZE                 SZ_2G /* 2GB DDR */
85
86 /* UART */
87 #define CONFIG_MXC_UART_BASE            UART_BASE_ADDR(1)
88
89 /* Monitor Command Prompt */
90 #define CONFIG_SYS_CBSIZE               SZ_2K
91 #define CONFIG_SYS_MAXARGS              64
92 #define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE
93 #define CONFIG_SYS_PBSIZE               (CONFIG_SYS_CBSIZE + \
94                                         sizeof(CONFIG_SYS_PROMPT) + 16)
95
96 /* ENET */
97 #define CONFIG_FEC_MXC_PHYADDR          7
98
99 /* USB Configs */
100 #define CONFIG_EHCI_HCD_INIT_AFTER_RESET
101 #define CONFIG_MXC_USB_PORTSC   (PORT_PTS_UTMI | PORT_PTS_PTW)
102 #define CONFIG_USB_MAX_CONTROLLER_COUNT 2
103
104 #endif /* __VERDIN_IMX8MM_H */