include/configs/novena.h

   1 /* SPDX-License-Identifier: GPL-2.0+ */
   2 /*
   3  * Configuration settings for the Novena U-Boot.
   4  *
   5  * Copyright (C) 2014 Marek Vasut <marex@denx.de>
   6  */
   7
   8 #ifndef __CONFIG_H
   9 #define __CONFIG_H
  10
  11 /* System configurations */
  12
  13 #include "mx6_common.h"
  14
  15 /* U-Boot Commands */
  16
  17 /* U-Boot general configurations */
  18
  19 /* U-Boot environment */
  20 /*
  21  * Environment is on MMC, starting at offset 512KiB from start of the card.
  22  * Please place first partition at offset 1MiB from the start of the card
  23  * as recommended by GNU/fdisk. See below for details:
  24  * http://homepage.ntlworld.com./jonathan.deboynepollard/FGA/disc-partition-alignment.html
  25  */
  26
  27 /* Booting Linux */
  28 #define CONFIG_HOSTNAME                 "novena"
  29
  30 /* Physical Memory Map */
  31 #define PHYS_SDRAM                      MMDC0_ARB_BASE_ADDR
  32
  33 #define CONFIG_SYS_SDRAM_BASE           PHYS_SDRAM
  34 #define CONFIG_SYS_INIT_RAM_ADDR        IRAM_BASE_ADDR
  35 #define CONFIG_SYS_INIT_RAM_SIZE        IRAM_SIZE
  36
  37 #define CONFIG_SYS_INIT_SP_OFFSET \
  38         (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
  39 #define CONFIG_SYS_INIT_SP_ADDR \
  40         (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
  41
  42 /* SPL */
  43 #include "imx6_spl.h"                   /* common IMX6 SPL configuration */
  44
  45 /* Ethernet Configuration */
  46 #ifdef CONFIG_SPL_BUILD
  47 #undef CONFIG_DM_ETH
  48 #endif
  49
  50 /* I2C */
  51 #define CONFIG_I2C_MULTI_BUS
  52 #define CONFIG_SYS_SPD_BUS_NUM          0
  53
  54 /* I2C EEPROM */
  55
  56 /* MMC Configs */
  57 #define CONFIG_SYS_FSL_ESDHC_ADDR       0
  58 #define CONFIG_SYS_FSL_USDHC_NUM        2
  59
  60 /* PCI express */
  61 #ifdef CONFIG_CMD_PCI
  62 #define CONFIG_PCI_SCAN_SHOW
  63 #define CONFIG_PCIE_IMX
  64 #define CONFIG_PCIE_IMX_PERST_GPIO      IMX_GPIO_NR(3, 29)
  65 #define CONFIG_PCIE_IMX_POWER_GPIO      IMX_GPIO_NR(7, 12)
  66 #endif
  67
  68 /* PMIC */
  69 #define CONFIG_POWER_PFUZE100
  70 #define CONFIG_POWER_PFUZE100_I2C_ADDR  0x08
  71
  72 /* SATA Configs */
  73 #define CONFIG_LBA48
  74
  75 /* UART */
  76 #define CONFIG_MXC_UART_BASE            UART2_BASE
  77
  78 /* USB Configs */
  79 #ifdef CONFIG_CMD_USB
  80 #define CONFIG_USB_MAX_CONTROLLER_COUNT 2
  81 #define CONFIG_MXC_USB_PORTSC           (PORT_PTS_UTMI | PORT_PTS_PTW)
  82 #define CONFIG_MXC_USB_FLAGS            0
  83 /* Gadget part */
  84 #define CONFIG_USBD_HS
  85 #endif
  86
  87 /* Video output */
  88 #define CONFIG_IMX_HDMI
  89 #define CONFIG_IMX_VIDEO_SKIP
  90
  91 /* Extra U-Boot environment. */
  92 #ifndef CONFIG_SPL_BUILD
  93 #define CONFIG_EXTRA_ENV_SETTINGS                                       \
  94         "fdt_high=0xffffffff\0"                                         \
  95         "initrd_high=0xffffffff\0"                                      \
  96         "consdev=ttymxc1\0"                                             \
  97         "baudrate=115200\0"                                             \
  98         "bootdev=/dev/mmcblk0p1\0"                                      \
  99         "rootdev=/dev/mmcblk0p2\0"                                      \
 100         "netdev=eth0\0"                                                 \
 101         "kernel_addr_r="__stringify(CONFIG_SYS_LOAD_ADDR)"\0"           \
 102         "pxefile_addr_r="__stringify(CONFIG_SYS_LOAD_ADDR)"\0"          \
 103         "scriptaddr="__stringify(CONFIG_SYS_LOAD_ADDR)"\0"                      \
 104         "ramdisk_addr_r=0x28000000\0"                                   \
 105         "fdt_addr_r=0x18000000\0"                                       \
 106         "fdtfile=imx6q-novena.dtb\0"                                    \
 107         "stdout=serial,vidconsole\0"                                    \
 108         "stderr=serial,vidconsole\0"                                    \
 109         "addcons="                                                      \
 110                 "setenv bootargs ${bootargs} "                          \
 111                 "console=${consdev},${baudrate}\0"                      \
 112         "addip="                                                        \
 113                 "setenv bootargs ${bootargs} "                          \
 114                 "ip=${ipaddr}:${serverip}:${gatewayip}:"                \
 115                         "${netmask}:${hostname}:${netdev}:off\0"        \
 116         "addmisc="                                                      \
 117                 "setenv bootargs ${bootargs} ${miscargs}\0"             \
 118         "addargs=run addcons addmisc\0"                                 \
 119         "mmcload="                                                      \
 120                 "mmc rescan ; "                                         \
 121                 "ext4load mmc 0:1 ${kernel_addr_r} ${bootfile}\0"       \
 122         "netload="                                                      \
 123                 "tftp ${kernel_addr_r} ${hostname}/${bootfile}\0"       \
 124         "miscargs=nohlt panic=1\0"                                      \
 125         "mmcargs=setenv bootargs root=${rootdev} rw rootwait\0"         \
 126         "nfsargs="                                                      \
 127                 "setenv bootargs root=/dev/nfs rw "                     \
 128                         "nfsroot=${serverip}:${rootpath},v3,tcp\0"      \
 129         "mmc_mmc="                                                      \
 130                 "run mmcload mmcargs addargs ; "                        \
 131                 "bootm ${kernel_addr_r}\0"                              \
 132         "mmc_nfs="                                                      \
 133                 "run mmcload nfsargs addip addargs ; "                  \
 134                 "bootm ${kernel_addr_r}\0"                              \
 135         "net_mmc="                                                      \
 136                 "run netload mmcargs addargs ; "                        \
 137                 "bootm ${kernel_addr_r}\0"                              \
 138         "net_nfs="                                                      \
 139                 "run netload nfsargs addip addargs ; "                  \
 140                 "bootm ${kernel_addr_r}\0"                              \
 141         "update_sd_spl_filename=SPL\0"                                  \
 142         "update_sd_uboot_filename=u-boot.img\0"                         \
 143         "update_sd_firmware="   /* Update the SD firmware partition */  \
 144                 "if mmc rescan ; then "                                 \
 145                 "if dhcp ${update_sd_spl_filename} ; then "             \
 146                 "mmc write ${loadaddr} 2 0x200 ; "                      \
 147                 "fi ; "                                                 \
 148                 "if dhcp ${update_sd_uboot_filename} ; then "           \
 149                 "fatwrite mmc 0:1 ${loadaddr} u-boot.img ${filesize} ; "\
 150                 "fi ; "                                                 \
 151                 "fi\0"                                                  \
 152         BOOTENV
 153
 154 #define BOOT_TARGET_DEVICES(func) \
 155         func(MMC, mmc, 0) \
 156         func(USB, usb, 0) \
 157         func(SATA, sata, 0) \
 158         func(PXE, pxe, na) \
 159         func(DHCP, dhcp, na)
 160
 161 #include <config_distro_bootcmd.h>
 162
 163 #else
 164 #define CONFIG_EXTRA_ENV_SETTINGS
 165 #endif /* CONFIG_SPL_BUILD */
 166
 167 #endif                          /* __CONFIG_H */