board: Add uCRobotics Bubblegum-96 board support
[platform/kernel/u-boot.git] / include / configs / ls1046ardb.h
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * Copyright 2016 Freescale Semiconductor
4  */
5
6 #ifndef __LS1046ARDB_H__
7 #define __LS1046ARDB_H__
8
9 #include "ls1046a_common.h"
10
11 #define CONFIG_SYS_CLK_FREQ             100000000
12 #define CONFIG_DDR_CLK_FREQ             100000000
13
14 #define CONFIG_LAYERSCAPE_NS_ACCESS
15 #define CONFIG_MISC_INIT_R
16
17 #define CONFIG_DIMM_SLOTS_PER_CTLR      1
18 /* Physical Memory Map */
19 #define CONFIG_CHIP_SELECTS_PER_CTRL    4
20 #define CONFIG_NR_DRAM_BANKS            2
21
22 #define CONFIG_DDR_SPD
23 #define SPD_EEPROM_ADDRESS              0x51
24 #define CONFIG_SYS_SPD_BUS_NUM          0
25
26 #define CONFIG_DDR_ECC
27 #define CONFIG_ECC_INIT_VIA_DDRCONTROLLER
28 #define CONFIG_MEM_INIT_VALUE           0xdeadbeef
29 #define CONFIG_FSL_DDR_BIST     /* enable built-in memory test */
30 #ifndef CONFIG_SPL
31 #define CONFIG_FSL_DDR_INTERACTIVE      /* Interactive debugging */
32 #endif
33
34 #ifdef CONFIG_RAMBOOT_PBL
35 #define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1046ardb/ls1046ardb_pbi.cfg
36 #endif
37
38 #ifdef CONFIG_SD_BOOT
39 #ifdef CONFIG_EMMC_BOOT
40 #define CONFIG_SYS_FSL_PBL_RCW \
41         board/freescale/ls1046ardb/ls1046ardb_rcw_emmc.cfg
42 #else
43 #define CONFIG_SYS_FSL_PBL_RCW board/freescale/ls1046ardb/ls1046ardb_rcw_sd.cfg
44 #endif
45 #endif
46
47 #ifndef SPL_NO_IFC
48 /* IFC */
49 #define CONFIG_FSL_IFC
50 /*
51  * NAND Flash Definitions
52  */
53 #define CONFIG_NAND_FSL_IFC
54 #endif
55
56 #define CONFIG_SYS_NAND_BASE            0x7e800000
57 #define CONFIG_SYS_NAND_BASE_PHYS       CONFIG_SYS_NAND_BASE
58
59 #define CONFIG_SYS_NAND_CSPR_EXT        (0x0)
60 #define CONFIG_SYS_NAND_CSPR    (CSPR_PHYS_ADDR(CONFIG_SYS_NAND_BASE_PHYS) \
61                                 | CSPR_PORT_SIZE_8      \
62                                 | CSPR_MSEL_NAND        \
63                                 | CSPR_V)
64 #define CONFIG_SYS_NAND_AMASK   IFC_AMASK(64 * 1024)
65 #define CONFIG_SYS_NAND_CSOR    (CSOR_NAND_ECC_ENC_EN   /* ECC on encode */ \
66                                 | CSOR_NAND_ECC_DEC_EN  /* ECC on decode */ \
67                                 | CSOR_NAND_ECC_MODE_8  /* 8-bit ECC */ \
68                                 | CSOR_NAND_RAL_3       /* RAL = 3 Bytes */ \
69                                 | CSOR_NAND_PGS_4K      /* Page Size = 4K */ \
70                                 | CSOR_NAND_SPRZ_224    /* Spare size = 224 */ \
71                                 | CSOR_NAND_PB(64))     /* 64 Pages Per Block */
72
73 #define CONFIG_SYS_NAND_ONFI_DETECTION
74
75 #define CONFIG_SYS_NAND_FTIM0           (FTIM0_NAND_TCCST(0x7) | \
76                                         FTIM0_NAND_TWP(0x18)   | \
77                                         FTIM0_NAND_TWCHT(0x7) | \
78                                         FTIM0_NAND_TWH(0xa))
79 #define CONFIG_SYS_NAND_FTIM1           (FTIM1_NAND_TADLE(0x32) | \
80                                         FTIM1_NAND_TWBE(0x39)  | \
81                                         FTIM1_NAND_TRR(0xe)   | \
82                                         FTIM1_NAND_TRP(0x18))
83 #define CONFIG_SYS_NAND_FTIM2           (FTIM2_NAND_TRAD(0xf) | \
84                                         FTIM2_NAND_TREH(0xa) | \
85                                         FTIM2_NAND_TWHRE(0x1e))
86 #define CONFIG_SYS_NAND_FTIM3           0x0
87
88 #define CONFIG_SYS_NAND_BASE_LIST       { CONFIG_SYS_NAND_BASE }
89 #define CONFIG_SYS_MAX_NAND_DEVICE      1
90 #define CONFIG_MTD_NAND_VERIFY_WRITE
91
92 #define CONFIG_SYS_NAND_BLOCK_SIZE      (128 * 1024)
93
94 /*
95  * CPLD
96  */
97 #define CONFIG_SYS_CPLD_BASE            0x7fb00000
98 #define CPLD_BASE_PHYS                  CONFIG_SYS_CPLD_BASE
99
100 #define CONFIG_SYS_CPLD_CSPR_EXT        (0x0)
101 #define CONFIG_SYS_CPLD_CSPR            (CSPR_PHYS_ADDR(CPLD_BASE_PHYS) | \
102                                         CSPR_PORT_SIZE_8 | \
103                                         CSPR_MSEL_GPCM | \
104                                         CSPR_V)
105 #define CONFIG_SYS_CPLD_AMASK           IFC_AMASK(64 * 1024)
106 #define CONFIG_SYS_CPLD_CSOR            CSOR_NOR_ADM_SHIFT(16)
107
108 /* CPLD Timing parameters for IFC GPCM */
109 #define CONFIG_SYS_CPLD_FTIM0           (FTIM0_GPCM_TACSE(0x0e) | \
110                                         FTIM0_GPCM_TEADC(0x0e) | \
111                                         FTIM0_GPCM_TEAHC(0x0e))
112 #define CONFIG_SYS_CPLD_FTIM1           (FTIM1_GPCM_TACO(0xff) | \
113                                         FTIM1_GPCM_TRAD(0x3f))
114 #define CONFIG_SYS_CPLD_FTIM2           (FTIM2_GPCM_TCS(0xf) | \
115                                         FTIM2_GPCM_TCH(0xf) | \
116                                         FTIM2_GPCM_TWP(0x3E))
117 #define CONFIG_SYS_CPLD_FTIM3           0x0
118
119 /* IFC Timing Params */
120 #define CONFIG_SYS_CSPR0_EXT            CONFIG_SYS_NAND_CSPR_EXT
121 #define CONFIG_SYS_CSPR0                CONFIG_SYS_NAND_CSPR
122 #define CONFIG_SYS_AMASK0               CONFIG_SYS_NAND_AMASK
123 #define CONFIG_SYS_CSOR0                CONFIG_SYS_NAND_CSOR
124 #define CONFIG_SYS_CS0_FTIM0            CONFIG_SYS_NAND_FTIM0
125 #define CONFIG_SYS_CS0_FTIM1            CONFIG_SYS_NAND_FTIM1
126 #define CONFIG_SYS_CS0_FTIM2            CONFIG_SYS_NAND_FTIM2
127 #define CONFIG_SYS_CS0_FTIM3            CONFIG_SYS_NAND_FTIM3
128
129 #define CONFIG_SYS_CSPR2_EXT            CONFIG_SYS_CPLD_CSPR_EXT
130 #define CONFIG_SYS_CSPR2                CONFIG_SYS_CPLD_CSPR
131 #define CONFIG_SYS_AMASK2               CONFIG_SYS_CPLD_AMASK
132 #define CONFIG_SYS_CSOR2                CONFIG_SYS_CPLD_CSOR
133 #define CONFIG_SYS_CS2_FTIM0            CONFIG_SYS_CPLD_FTIM0
134 #define CONFIG_SYS_CS2_FTIM1            CONFIG_SYS_CPLD_FTIM1
135 #define CONFIG_SYS_CS2_FTIM2            CONFIG_SYS_CPLD_FTIM2
136 #define CONFIG_SYS_CS2_FTIM3            CONFIG_SYS_CPLD_FTIM3
137
138 /* EEPROM */
139 #define CONFIG_ID_EEPROM
140 #define CONFIG_SYS_I2C_EEPROM_NXID
141 #define CONFIG_SYS_EEPROM_BUS_NUM               0
142 #define CONFIG_SYS_I2C_EEPROM_ADDR              0x53
143 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN          1
144 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS       3
145 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS   5
146 #define I2C_RETIMER_ADDR                        0x18
147
148 /* PMIC */
149 #define CONFIG_POWER
150 #ifdef CONFIG_POWER
151 #define CONFIG_POWER_I2C
152 #endif
153
154 /*
155  * Environment
156  */
157 #ifndef SPL_NO_ENV
158 #define CONFIG_ENV_OVERWRITE
159 #endif
160
161 #if defined(CONFIG_SD_BOOT)
162 #define CONFIG_SYS_MMC_ENV_DEV          0
163 #define CONFIG_ENV_OFFSET               (3 * 1024 * 1024)
164 #define CONFIG_ENV_SIZE                 0x2000
165 #else
166 #define CONFIG_ENV_SIZE                 0x2000          /* 8KB */
167 #define CONFIG_ENV_OFFSET               0x300000        /* 3MB */
168 #define CONFIG_ENV_SECT_SIZE            0x40000         /* 256KB */
169 #endif
170
171 #define AQR105_IRQ_MASK                 0x80000000
172 /* FMan */
173 #ifndef SPL_NO_FMAN
174
175 #ifdef CONFIG_NET
176 #define CONFIG_PHY_REALTEK
177 #endif
178
179 #ifdef CONFIG_SYS_DPAA_FMAN
180 #define CONFIG_FMAN_ENET
181 #define CONFIG_PHY_AQUANTIA
182 #define CONFIG_PHYLIB_10G
183 #define RGMII_PHY1_ADDR                 0x1
184 #define RGMII_PHY2_ADDR                 0x2
185
186 #define SGMII_PHY1_ADDR                 0x3
187 #define SGMII_PHY2_ADDR                 0x4
188
189 #define FM1_10GEC1_PHY_ADDR             0x0
190
191 #define FDT_SEQ_MACADDR_FROM_ENV
192
193 #define CONFIG_ETHPRIME                 "FM1@DTSEC3"
194 #endif
195
196 #endif
197
198 /* QSPI device */
199 #ifndef SPL_NO_QSPI
200 #ifdef CONFIG_FSL_QSPI
201 #define CONFIG_SPI_FLASH_SPANSION
202 #define FSL_QSPI_FLASH_SIZE             (1 << 26)
203 #define FSL_QSPI_FLASH_NUM              2
204 #endif
205 #endif
206
207 #ifndef SPL_NO_MISC
208 #undef CONFIG_BOOTCOMMAND
209 #if defined(CONFIG_QSPI_BOOT)
210 #define CONFIG_BOOTCOMMAND "run distro_bootcmd; run qspi_bootcmd; "     \
211                            "env exists secureboot && esbc_halt;;"
212 #elif defined(CONFIG_SD_BOOT)
213 #define CONFIG_BOOTCOMMAND "run distro_bootcmd;run sd_bootcmd; "        \
214                            "env exists secureboot && esbc_halt;"
215 #endif
216 #endif
217
218 #include <asm/fsl_secure_boot.h>
219
220 #endif /* __LS1046ARDB_H__ */