include/configs/ls1012a_common.h

   1 /*
   2  * Copyright 2016 Freescale Semiconductor
   3  *
   4  * SPDX-License-Identifier:     GPL-2.0+
   5  */
   6
   7 #ifndef __LS1012A_COMMON_H
   8 #define __LS1012A_COMMON_H
   9
  10 #define CONFIG_FSL_LAYERSCAPE
  11 #define CONFIG_GICV2
  12
  13 #include <asm/arch/config.h>
  14 #include <asm/arch/stream_id_lsch2.h>
  15
  16 #define CONFIG_SUPPORT_RAW_INITRD
  17
  18 #define CONFIG_DISPLAY_BOARDINFO_LATE
  19
  20 #define CONFIG_SYS_TEXT_BASE            0x40100000
  21
  22 #define CONFIG_SYS_CLK_FREQ             125000000
  23
  24 #define CONFIG_SKIP_LOWLEVEL_INIT
  25
  26 #define CONFIG_SYS_INIT_SP_ADDR         (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
  27 #define CONFIG_SYS_LOAD_ADDR    (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)
  28
  29 #define CONFIG_SYS_DDR_SDRAM_BASE       0x80000000
  30 #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY       0
  31 #define CONFIG_SYS_SDRAM_BASE           CONFIG_SYS_DDR_SDRAM_BASE
  32 #define CONFIG_SYS_DDR_BLOCK2_BASE     0x880000000ULL
  33
  34 /* Generic Timer Definitions */
  35 #define COUNTER_FREQUENCY               CONFIG_SYS_CLK_FREQ/4   /* 25MHz */
  36
  37 /* CSU */
  38 #define CONFIG_LAYERSCAPE_NS_ACCESS
  39
  40 /* Size of malloc() pool */
  41 #define CONFIG_SYS_MALLOC_LEN           (CONFIG_ENV_SIZE + 128 * 1024)
  42
  43 /*SPI device */
  44 #ifdef CONFIG_QSPI_BOOT
  45 #define CONFIG_SYS_QE_FW_IN_SPIFLASH
  46 #define CONFIG_SYS_FMAN_FW_ADDR         0x400d0000
  47 #define CONFIG_ENV_SPI_BUS              0
  48 #define CONFIG_ENV_SPI_CS               0
  49 #define CONFIG_ENV_SPI_MAX_HZ           1000000
  50 #define CONFIG_ENV_SPI_MODE             0x03
  51 #define CONFIG_SPI_FLASH_SPANSION
  52 #define CONFIG_FSL_SPI_INTERFACE
  53 #define CONFIG_SF_DATAFLASH
  54
  55 #define CONFIG_FSL_QSPI
  56 #define QSPI0_AMBA_BASE         0x40000000
  57 #define CONFIG_SPI_FLASH_SPANSION
  58 #define CONFIG_SPI_FLASH_BAR
  59
  60 #define FSL_QSPI_FLASH_SIZE             (1 << 24)
  61 #define FSL_QSPI_FLASH_NUM              2
  62
  63 /*
  64  * Environment
  65  */
  66 #define CONFIG_ENV_OVERWRITE
  67
  68 #define CONFIG_ENV_IS_IN_SPI_FLASH
  69 #define CONFIG_ENV_SIZE                 0x40000          /* 256KB */
  70 #define CONFIG_ENV_OFFSET               0x200000        /* 2MB */
  71 #define CONFIG_ENV_SECT_SIZE            0x40000
  72 #endif
  73
  74 /* I2C */
  75 #define CONFIG_SYS_I2C
  76 #define CONFIG_SYS_I2C_MXC
  77 #define CONFIG_SYS_I2C_MXC_I2C1         /* enable I2C bus 1 */
  78 #define CONFIG_SYS_I2C_MXC_I2C2         /* enable I2C bus 2 */
  79
  80 #define CONFIG_CONS_INDEX       1
  81 #define CONFIG_SYS_NS16550_SERIAL
  82 #define CONFIG_SYS_NS16550_REG_SIZE     1
  83 #define CONFIG_SYS_NS16550_CLK          (get_serial_clock())
  84
  85 #define CONFIG_SYS_BAUDRATE_TABLE       { 9600, 19200, 38400, 57600, 115200 }
  86
  87 /* Command line configuration */
  88 #define CONFIG_CMD_ENV
  89 #undef CONFIG_CMD_IMLS
  90
  91 #define CONFIG_SYS_HZ                   1000
  92
  93 #define CONFIG_HWCONFIG
  94 #define HWCONFIG_BUFFER_SIZE            128
  95
  96 /* Initial environment variables */
  97 #define CONFIG_EXTRA_ENV_SETTINGS               \
  98         "verify=no\0"                           \
  99         "loadaddr=0x80100000\0"                 \
 100         "kernel_addr=0x100000\0"                \
 101         "fdt_high=0xffffffffffffffff\0"         \
 102         "initrd_high=0xffffffffffffffff\0"      \
 103         "kernel_start=0xa00000\0"               \
 104         "kernel_load=0xa0000000\0"              \
 105         "kernel_size=0x2800000\0"               \
 106
 107 #define CONFIG_BOOTARGS         "console=ttyS0,115200 root=/dev/ram0 " \
 108                                 "earlycon=uart8250,mmio,0x21c0500 quiet lpj=250000"
 109 #define CONFIG_BOOTCOMMAND              "sf probe 0:0; sf read $kernel_load "\
 110                                         "$kernel_start $kernel_size && "\
 111                                         "bootm $kernel_load"
 112
 113 /* Monitor Command Prompt */
 114 #define CONFIG_SYS_CBSIZE               512     /* Console I/O Buffer Size */
 115 #define CONFIG_SYS_PBSIZE               (CONFIG_SYS_CBSIZE + \
 116                                         sizeof(CONFIG_SYS_PROMPT) + 16)
 117 #define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE /* Boot args buffer */
 118 #define CONFIG_SYS_LONGHELP
 119 #define CONFIG_CMDLINE_EDITING          1
 120 #define CONFIG_AUTO_COMPLETE
 121 #define CONFIG_SYS_MAXARGS              64      /* max command args */
 122
 123 #define CONFIG_PANIC_HANG
 124 #define CONFIG_SYS_BOOTM_LEN   (64 << 20)      /* Increase max gunzip size */
 125
 126 #endif /* __LS1012A_COMMON_H */