include/configs/imx8mq_evk.h

   1 /* SPDX-License-Identifier: GPL-2.0+ */
   2 /*
   3  * Copyright 2018 NXP
   4  */
   5
   6 #ifndef __IMX8M_EVK_H
   7 #define __IMX8M_EVK_H
   8
   9 #include <linux/sizes.h>
  10 #include <linux/stringify.h>
  11 #include <asm/arch/imx-regs.h>
  12
  13 #define CONFIG_SYS_BOOTM_LEN            (32 * SZ_1M)
  14
  15 #define CONFIG_SPL_MAX_SIZE             (124 * 1024)
  16 #define CONFIG_SYS_MONITOR_LEN          (512 * 1024)
  17 #define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR
  18 #define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x300
  19
  20 #ifdef CONFIG_SPL_BUILD
  21 /*#define CONFIG_ENABLE_DDR_TRAINING_DEBUG*/
  22 #define CONFIG_SPL_WATCHDOG_SUPPORT
  23 #define CONFIG_SPL_DRIVERS_MISC_SUPPORT
  24 #define CONFIG_SPL_POWER_SUPPORT
  25 #define CONFIG_SPL_I2C_SUPPORT
  26 #define CONFIG_SPL_LDSCRIPT             "arch/arm/cpu/armv8/u-boot-spl.lds"
  27 #define CONFIG_SPL_STACK                0x187FF0
  28 #define CONFIG_SPL_LIBCOMMON_SUPPORT
  29 #define CONFIG_SPL_LIBGENERIC_SUPPORT
  30 #define CONFIG_SPL_GPIO_SUPPORT
  31 #define CONFIG_SPL_MMC_SUPPORT
  32 #define CONFIG_SPL_BSS_START_ADDR      0x00180000
  33 #define CONFIG_SPL_BSS_MAX_SIZE        0x2000   /* 8 KB */
  34 #define CONFIG_SYS_SPL_MALLOC_START    0x42200000
  35 #define CONFIG_SYS_SPL_MALLOC_SIZE    0x80000   /* 512 KB */
  36 #define CONFIG_SYS_SPL_PTE_RAM_BASE    0x41580000
  37
  38 /* malloc f used before GD_FLG_FULL_MALLOC_INIT set */
  39 #define CONFIG_MALLOC_F_ADDR            0x182000
  40 /* For RAW image gives a error info not panic */
  41 #define CONFIG_SPL_ABORT_ON_RAW_IMAGE
  42
  43 #undef CONFIG_DM_MMC
  44 #undef CONFIG_DM_PMIC
  45 #undef CONFIG_DM_PMIC_PFUZE100
  46
  47 #define CONFIG_SYS_I2C
  48 #define CONFIG_SYS_I2C_MXC_I2C1         /* enable I2C bus 1 */
  49 #define CONFIG_SYS_I2C_MXC_I2C2         /* enable I2C bus 2 */
  50 #define CONFIG_SYS_I2C_MXC_I2C3         /* enable I2C bus 3 */
  51
  52 #define CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG
  53
  54 #define CONFIG_POWER
  55 #define CONFIG_POWER_I2C
  56 #define CONFIG_POWER_PFUZE100
  57 #define CONFIG_POWER_PFUZE100_I2C_ADDR 0x08
  58 #endif
  59
  60 #define CONFIG_REMAKE_ELF
  61
  62 /* ENET Config */
  63 /* ENET1 */
  64 #if defined(CONFIG_CMD_NET)
  65 #define CONFIG_MII
  66 #define CONFIG_ETHPRIME                 "FEC"
  67
  68 #define CONFIG_FEC_MXC
  69 #define CONFIG_FEC_XCV_TYPE             RGMII
  70 #define CONFIG_FEC_MXC_PHYADDR          0
  71 #define FEC_QUIRK_ENET_MAC
  72
  73 #define CONFIG_PHY_GIGE
  74 #define IMX_FEC_BASE                    0x30BE0000
  75 #endif
  76
  77 #define CONFIG_MFG_ENV_SETTINGS \
  78         "mfgtool_args=setenv bootargs console=${console},${baudrate} " \
  79                 "rdinit=/linuxrc " \
  80                 "g_mass_storage.stall=0 g_mass_storage.removable=1 " \
  81                 "g_mass_storage.idVendor=0x066F g_mass_storage.idProduct=0x37FF "\
  82                 "g_mass_storage.iSerialNumber=\"\" "\
  83                 "clk_ignore_unused "\
  84                 "\0" \
  85         "initrd_addr=0x43800000\0" \
  86         "bootcmd_mfg=run mfgtool_args;booti ${loadaddr} ${initrd_addr} ${fdt_addr};\0" \
  87 /* Initial environment variables */
  88 #define CONFIG_EXTRA_ENV_SETTINGS               \
  89         CONFIG_MFG_ENV_SETTINGS \
  90         "script=boot.scr\0" \
  91         "image=Image\0" \
  92         "console=ttymxc0,115200\0" \
  93         "fdt_addr=0x43000000\0"                 \
  94         "boot_fdt=try\0" \
  95         "fdt_file=imx8mq-evk.dtb\0" \
  96         "initrd_addr=0x43800000\0"              \
  97         "bootm_size=0x10000000\0" \
  98         "mmcdev="__stringify(CONFIG_SYS_MMC_ENV_DEV)"\0" \
  99         "mmcpart=" __stringify(CONFIG_SYS_MMC_IMG_LOAD_PART) "\0" \
 100         "mmcroot=" CONFIG_MMCROOT " rootwait rw\0" \
 101         "mmcautodetect=yes\0" \
 102         "mmcargs=setenv bootargs console=${console} root=${mmcroot}\0 " \
 103         "loadbootscript=fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${script};\0" \
 104         "bootscript=echo Running bootscript from mmc ...; " \
 105                 "source\0" \
 106         "loadimage=fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} ${image}\0" \
 107         "loadfdt=fatload mmc ${mmcdev}:${mmcpart} ${fdt_addr} ${fdt_file}\0" \
 108         "mmcboot=echo Booting from mmc ...; " \
 109                 "run mmcargs; " \
 110                 "if test ${boot_fdt} = yes || test ${boot_fdt} = try; then " \
 111                         "if run loadfdt; then " \
 112                                 "booti ${loadaddr} - ${fdt_addr}; " \
 113                         "else " \
 114                                 "echo WARN: Cannot load the DT; " \
 115                         "fi; " \
 116                 "else " \
 117                         "echo wait for boot; " \
 118                 "fi;\0" \
 119         "netargs=setenv bootargs console=${console} " \
 120                 "root=/dev/nfs " \
 121                 "ip=dhcp nfsroot=${serverip}:${nfsroot},v3,tcp\0" \
 122         "netboot=echo Booting from net ...; " \
 123                 "run netargs;  " \
 124                 "if test ${ip_dyn} = yes; then " \
 125                         "setenv get_cmd dhcp; " \
 126                 "else " \
 127                         "setenv get_cmd tftp; " \
 128                 "fi; " \
 129                 "${get_cmd} ${loadaddr} ${image}; " \
 130                 "if test ${boot_fdt} = yes || test ${boot_fdt} = try; then " \
 131                         "if ${get_cmd} ${fdt_addr} ${fdt_file}; then " \
 132                                 "booti ${loadaddr} - ${fdt_addr}; " \
 133                         "else " \
 134                                 "echo WARN: Cannot load the DT; " \
 135                         "fi; " \
 136                 "else " \
 137                         "booti; " \
 138                 "fi;\0"
 139
 140 #define CONFIG_BOOTCOMMAND \
 141            "mmc dev ${mmcdev}; if mmc rescan; then " \
 142                    "if run loadbootscript; then " \
 143                            "run bootscript; " \
 144                    "else " \
 145                            "if run loadimage; then " \
 146                                    "run mmcboot; " \
 147                            "else run netboot; " \
 148                            "fi; " \
 149                    "fi; " \
 150            "else booti ${loadaddr} - ${fdt_addr}; fi"
 151
 152 /* Link Definitions */
 153 #define CONFIG_LOADADDR                 0x40480000
 154
 155 #define CONFIG_SYS_LOAD_ADDR           CONFIG_LOADADDR
 156
 157 #define CONFIG_SYS_INIT_RAM_ADDR        0x40000000
 158 #define CONFIG_SYS_INIT_RAM_SIZE        0x80000
 159 #define CONFIG_SYS_INIT_SP_OFFSET \
 160         (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
 161 #define CONFIG_SYS_INIT_SP_ADDR \
 162         (CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
 163
 164 #define CONFIG_MMCROOT                  "/dev/mmcblk1p2"  /* USDHC2 */
 165
 166 /* Size of malloc() pool */
 167 #define CONFIG_SYS_MALLOC_LEN           ((CONFIG_ENV_SIZE + (2 * 1024)) * 1024)
 168
 169 #define CONFIG_SYS_SDRAM_BASE           0x40000000
 170 #define PHYS_SDRAM                      0x40000000
 171 #define PHYS_SDRAM_SIZE                 0xC0000000 /* 3GB DDR */
 172
 173 #define CONFIG_MXC_UART_BASE            UART1_BASE_ADDR
 174
 175 /* Monitor Command Prompt */
 176 #undef CONFIG_SYS_PROMPT
 177 #define CONFIG_SYS_PROMPT               "u-boot=> "
 178 #define CONFIG_SYS_PROMPT_HUSH_PS2      "> "
 179 #define CONFIG_SYS_CBSIZE               1024
 180 #define CONFIG_SYS_MAXARGS              64
 181 #define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE
 182 #define CONFIG_SYS_PBSIZE               (CONFIG_SYS_CBSIZE + \
 183                                         sizeof(CONFIG_SYS_PROMPT) + 16)
 184
 185 #define CONFIG_IMX_BOOTAUX
 186
 187 #define CONFIG_SYS_FSL_USDHC_NUM        2
 188 #define CONFIG_SYS_FSL_ESDHC_ADDR       0
 189
 190 #define CONFIG_SYS_MMC_IMG_LOAD_PART    1
 191
 192 #define CONFIG_MXC_GPIO
 193
 194 /* I2C Configs */
 195 #define CONFIG_SYS_I2C_SPEED              100000
 196
 197 #define CONFIG_OF_SYSTEM_SETUP
 198
 199 #ifndef CONFIG_SPL_BUILD
 200 #define CONFIG_DM_PMIC
 201 #endif
 202
 203 #endif