include/configs/devkit3250.h

   1 /*
   2  * Embest/Timll DevKit3250 board configuration file
   3  *
   4  * Copyright (C) 2011-2015 Vladimir Zapolskiy <vz@mleia.com>
   5  *
   6  * SPDX-License-Identifier:     GPL-2.0+
   7  */
   8
   9 #ifndef __CONFIG_DEVKIT3250_H__
  10 #define __CONFIG_DEVKIT3250_H__
  11
  12 /* SoC and board defines */
  13 #include <linux/sizes.h>
  14 #include <asm/arch/cpu.h>
  15
  16 #define CONFIG_MACH_TYPE                MACH_TYPE_DEVKIT3250
  17
  18 #define CONFIG_SYS_ICACHE_OFF
  19 #define CONFIG_SYS_DCACHE_OFF
  20 #if !defined(CONFIG_SPL_BUILD)
  21 #define CONFIG_SKIP_LOWLEVEL_INIT
  22 #endif
  23
  24 /*
  25  * Memory configurations
  26  */
  27 #define CONFIG_NR_DRAM_BANKS            1
  28 #define CONFIG_SYS_MALLOC_LEN           SZ_1M
  29 #define CONFIG_SYS_SDRAM_BASE           EMC_DYCS0_BASE
  30 #define CONFIG_SYS_SDRAM_SIZE           SZ_64M
  31 #define CONFIG_SYS_TEXT_BASE            0x83F00000
  32 #define CONFIG_SYS_MEMTEST_START        (CONFIG_SYS_SDRAM_BASE + SZ_32K)
  33 #define CONFIG_SYS_MEMTEST_END          (CONFIG_SYS_TEXT_BASE - SZ_1M)
  34
  35 #define CONFIG_SYS_LOAD_ADDR            (CONFIG_SYS_SDRAM_BASE + SZ_32K)
  36
  37 #define CONFIG_SYS_INIT_SP_ADDR         (CONFIG_SYS_SDRAM_BASE + SZ_4K \
  38                                          - GENERATED_GBL_DATA_SIZE)
  39
  40 /*
  41  * Serial Driver
  42  */
  43 #define CONFIG_SYS_LPC32XX_UART         5   /* UART5 */
  44
  45 /*
  46  * DMA
  47  */
  48 #if !defined(CONFIG_SPL_BUILD)
  49 #define CONFIG_DMA_LPC32XX
  50 #endif
  51
  52 /*
  53  * I2C
  54  */
  55 #define CONFIG_SYS_I2C
  56 #define CONFIG_SYS_I2C_LPC32XX
  57 #define CONFIG_SYS_I2C_SPEED            100000
  58
  59 /*
  60  * GPIO
  61  */
  62 #define CONFIG_LPC32XX_GPIO
  63
  64 /*
  65  * SSP/SPI
  66  */
  67 #define CONFIG_LPC32XX_SSP
  68 #define CONFIG_LPC32XX_SSP_TIMEOUT      100000
  69
  70 /*
  71  * Ethernet
  72  */
  73 #define CONFIG_RMII
  74 #define CONFIG_PHY_SMSC
  75 #define CONFIG_LPC32XX_ETH
  76 #define CONFIG_PHYLIB
  77 #define CONFIG_PHY_ADDR                 0x1F
  78 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
  79
  80 /*
  81  * NOR Flash
  82  */
  83 #define CONFIG_SYS_MAX_FLASH_BANKS      1
  84 #define CONFIG_SYS_MAX_FLASH_SECT       71
  85 #define CONFIG_SYS_FLASH_BASE           EMC_CS0_BASE
  86 #define CONFIG_SYS_FLASH_SIZE           SZ_4M
  87 #define CONFIG_SYS_FLASH_CFI
  88
  89 /*
  90  * NAND controller
  91  */
  92 #define CONFIG_NAND_LPC32XX_SLC
  93 #define CONFIG_SYS_NAND_BASE            SLC_NAND_BASE
  94 #define CONFIG_SYS_MAX_NAND_DEVICE      1
  95 #define CONFIG_SYS_NAND_BASE_LIST       { CONFIG_SYS_NAND_BASE }
  96
  97 /*
  98  * NAND chip timings
  99  */
 100 #define CONFIG_LPC32XX_NAND_SLC_WDR_CLKS        14
 101 #define CONFIG_LPC32XX_NAND_SLC_WWIDTH          66666666
 102 #define CONFIG_LPC32XX_NAND_SLC_WHOLD           200000000
 103 #define CONFIG_LPC32XX_NAND_SLC_WSETUP          50000000
 104 #define CONFIG_LPC32XX_NAND_SLC_RDR_CLKS        14
 105 #define CONFIG_LPC32XX_NAND_SLC_RWIDTH          66666666
 106 #define CONFIG_LPC32XX_NAND_SLC_RHOLD           200000000
 107 #define CONFIG_LPC32XX_NAND_SLC_RSETUP          50000000
 108
 109 #define CONFIG_SYS_NAND_BLOCK_SIZE              0x20000
 110 #define CONFIG_SYS_NAND_PAGE_SIZE               NAND_LARGE_BLOCK_PAGE_SIZE
 111 #define CONFIG_SYS_NAND_USE_FLASH_BBT
 112
 113 #define CONFIG_CMD_JFFS2
 114 #define CONFIG_CMD_NAND
 115
 116 /*
 117  * USB
 118  */
 119 #define CONFIG_USB_OHCI_LPC32XX
 120 #define CONFIG_USB_ISP1301_I2C_ADDR             0x2d
 121
 122 /*
 123  * U-Boot General Configurations
 124  */
 125 #define CONFIG_SYS_LONGHELP
 126 #define CONFIG_SYS_CBSIZE               1024
 127 #define CONFIG_SYS_PBSIZE               \
 128         (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
 129 #define CONFIG_SYS_MAXARGS              16
 130 #define CONFIG_SYS_BARGSIZE             CONFIG_SYS_CBSIZE
 131
 132 #define CONFIG_AUTO_COMPLETE
 133 #define CONFIG_CMDLINE_EDITING
 134
 135 /*
 136  * Pass open firmware flat tree
 137  */
 138
 139 /*
 140  * Environment
 141  */
 142 #define CONFIG_ENV_IS_IN_NAND           1
 143 #define CONFIG_ENV_SIZE                 SZ_128K
 144 #define CONFIG_ENV_OFFSET               0x000A0000
 145
 146 #define CONFIG_BOOTCOMMAND                      \
 147         "dhcp; "                                \
 148         "tftp ${loadaddr} ${serverip}:${tftpdir}/${bootfile}; "         \
 149         "tftp ${dtbaddr} ${serverip}:${tftpdir}/devkit3250.dtb; "       \
 150         "setenv nfsargs ip=dhcp root=/dev/nfs nfsroot=${serverip}:${nfsroot},tcp; "     \
 151         "setenv bootargs ${bootargs} ${nfsargs} ${userargs}; "                  \
 152         "bootm ${loadaddr} - ${dtbaddr}"
 153
 154 #define CONFIG_EXTRA_ENV_SETTINGS               \
 155         "autoload=no\0"                         \
 156         "ethaddr=00:01:90:00:C0:81\0"           \
 157         "dtbaddr=0x81000000\0"                  \
 158         "nfsroot=/opt/projects/images/vladimir/oe/devkit3250/rootfs\0"  \
 159         "tftpdir=vladimir/oe/devkit3250\0"      \
 160         "userargs=oops=panic\0"
 161
 162 /*
 163  * U-Boot Commands
 164  */
 165
 166 /*
 167  * Boot Linux
 168  */
 169 #define CONFIG_CMDLINE_TAG
 170 #define CONFIG_SETUP_MEMORY_TAGS
 171
 172 #define CONFIG_BOOTFILE                 "uImage"
 173 #define CONFIG_BOOTARGS                 "console=ttyS0,115200n8"
 174 #define CONFIG_LOADADDR                 0x80008000
 175
 176 /*
 177  * SPL specific defines
 178  */
 179 /* SPL will be executed at offset 0 */
 180 #define CONFIG_SPL_TEXT_BASE            0x00000000
 181
 182 /* SPL will use SRAM as stack */
 183 #define CONFIG_SPL_STACK                0x0000FFF8
 184
 185 /* Use the framework and generic lib */
 186 #define CONFIG_SPL_FRAMEWORK
 187
 188 /* SPL will use serial */
 189
 190 /* SPL loads an image from NAND */
 191 #define CONFIG_SPL_NAND_SIMPLE
 192 #define CONFIG_SPL_NAND_RAW_ONLY
 193 #define CONFIG_SPL_NAND_DRIVERS
 194
 195 #define CONFIG_SPL_NAND_ECC
 196 #define CONFIG_SPL_NAND_SOFTECC
 197
 198 #define CONFIG_SPL_MAX_SIZE             0x20000
 199 #define CONFIG_SPL_PAD_TO               CONFIG_SPL_MAX_SIZE
 200
 201 /* U-Boot will be 0x60000 bytes, loaded and run at CONFIG_SYS_TEXT_BASE */
 202 #define CONFIG_SYS_NAND_U_BOOT_OFFS     0x40000
 203 #define CONFIG_SYS_NAND_U_BOOT_SIZE     0x60000
 204
 205 #define CONFIG_SYS_NAND_U_BOOT_START    CONFIG_SYS_TEXT_BASE
 206 #define CONFIG_SYS_NAND_U_BOOT_DST      CONFIG_SYS_TEXT_BASE
 207
 208 /* See common/spl/spl.c  spl_set_header_raw_uboot() */
 209 #define CONFIG_SYS_MONITOR_LEN          CONFIG_SYS_NAND_U_BOOT_SIZE
 210
 211 /*
 212  * Include SoC specific configuration
 213  */
 214 #include <asm/arch/config.h>
 215
 216 #endif  /* __CONFIG_DEVKIT3250_H__*/