1 /* SPDX-License-Identifier: GPL-2.0+ */
3 * Copyright 2020 Toradex
6 #ifndef __APALIS_IMX8X_H
7 #define __APALIS_IMX8X_H
9 #include <asm/arch/imx-regs.h>
10 #include <linux/sizes.h>
11 #include <linux/stringify.h>
13 #define CONFIG_SYS_FSL_ESDHC_ADDR 0
14 #define USDHC1_BASE_ADDR 0x5b010000
15 #define USDHC2_BASE_ADDR 0x5b020000
17 #define CONFIG_IPADDR 192.168.10.2
18 #define CONFIG_NETMASK 255.255.255.0
19 #define CONFIG_SERVERIP 192.168.10.1
21 #define MEM_LAYOUT_ENV_SETTINGS \
22 "kernel_addr_r=0x80280000\0" \
23 "fdt_addr_r=0x83100000\0" \
24 "ramdisk_addr_r=0x8a000000\0" \
25 "scriptaddr=0x83200000\0"
27 #ifdef CONFIG_AHAB_BOOT
28 #define AHAB_ENV "sec_boot=yes\0"
30 #define AHAB_ENV "sec_boot=no\0"
35 "m4_0_image=m4_0.bin\0" \
36 "loadm4image_0=fatload mmc ${mmcdev}:${mmcpart} ${loadaddr} " \
38 "m4boot_0=run loadm4image_0; dcache flush; bootaux ${loadaddr} 0\0" \
40 #define MFG_NAND_PARTITION ""
42 #define BOOT_TARGET_DEVICES(func) \
46 #include <config_distro_bootcmd.h>
47 #undef BOOTENV_RUN_NET_USB_START
48 #define BOOTENV_RUN_NET_USB_START ""
50 #define CONFIG_MFG_ENV_SETTINGS \
51 "mfgtool_args=setenv bootargs ${consoleargs} " \
52 "rdinit=/linuxrc g_mass_storage.stall=0 " \
53 "g_mass_storage.removable=1 g_mass_storage.idVendor=0x066F " \
54 "g_mass_storage.idProduct=0x37FF " \
55 "g_mass_storage.iSerialNumber=\"\" " MFG_NAND_PARTITION \
56 "${vidargs} clk_ignore_unused\0" \
57 "initrd_addr=0x83800000\0" \
58 "bootcmd_mfg=run mfgtool_args;booti ${loadaddr} ${initrd_addr} " \
61 /* Initial environment variables */
62 #define CONFIG_EXTRA_ENV_SETTINGS \
65 CONFIG_MFG_ENV_SETTINGS \
67 MEM_LAYOUT_ENV_SETTINGS \
69 "consoleargs=console=ttyLP3,${baudrate} earlycon\0" \
70 "fdt_file=imx8qxp-apalis-eval.dtb\0" \
71 "fdtfile=imx8qxp-apalis-eval.dtb\0" \
72 "finduuid=part uuid mmc ${mmcdev}:2 uuid\0" \
74 "initrd_addr=0x83800000\0" \
75 "mmcargs=setenv bootargs ${consoleargs} " \
76 "root=PARTUUID=${uuid} rootwait " \
77 "mmcdev=" __stringify(CONFIG_SYS_MMC_ENV_DEV) "\0" \
79 "netargs=setenv bootargs ${consoleargs} " \
80 "root=/dev/nfs ip=dhcp nfsroot=${serverip}:${nfsroot},v3,tcp " \
82 "nfsboot=run netargs; dhcp ${loadaddr} ${image}; tftp ${fdt_addr} " \
83 "apalis-imx8x/${fdt_file}; booti ${loadaddr} - " \
87 "update_uboot=askenv confirm Did you load u-boot-dtb.imx (y/N)?; " \
88 "if test \"$confirm\" = \"y\"; then " \
89 "setexpr blkcnt ${filesize} + 0x1ff && setexpr blkcnt " \
90 "${blkcnt} / 0x200; mmc dev 0 1; mmc write ${loadaddr} 0x0 " \
92 "vidargs=video=imxdpufb5:off video=imxdpufb6:off video=imxdpufb7:off\0"
94 /* Link Definitions */
96 #define CONFIG_SYS_INIT_SP_ADDR 0x80200000
98 /* Environment in eMMC, before config block at the end of 1st "boot sector" */
100 /* On Apalis iMX8X USDHC1 is eMMC, USDHC2 is 4-bit SD */
101 #define CONFIG_SYS_FSL_USDHC_NUM 2
103 #define CONFIG_SYS_BOOTM_LEN SZ_64M /* Increase max gunzip size */
105 #define CONFIG_SYS_SDRAM_BASE 0x80000000
106 #define PHYS_SDRAM_1 0x80000000
107 #define PHYS_SDRAM_2 0x880000000
108 #define PHYS_SDRAM_1_SIZE SZ_2G /* 2 GB */
109 #define PHYS_SDRAM_2_SIZE 0x00000000 /* 0 GB */
111 /* Monitor Command Prompt */
112 #define CONFIG_SYS_CBSIZE SZ_2K
113 #define CONFIG_SYS_MAXARGS 64
114 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
115 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \
116 sizeof(CONFIG_SYS_PROMPT) + 16)
118 /* Generic Timer Definitions */
119 #define COUNTER_FREQUENCY 8000000 /* 8MHz */
122 #define CONFIG_FEC_ENET_DEV 0
123 #define IMX_FEC_BASE 0x5b040000
124 #define CONFIG_FEC_MXC_PHYADDR 0x4
125 #define CONFIG_ETHPRIME "eth0"
126 #define CONFIG_FEC_XCV_TYPE RGMII
127 #define PHY_ANEG_TIMEOUT 20000
129 #endif /* __APALIS_IMX8X_H */