arm: Stop using CONFIG_SYS_GBL_DATA_OFFSET
[platform/kernel/u-boot.git] / include / configs / M5373EVB.h
1 /* SPDX-License-Identifier: GPL-2.0+ */
2 /*
3  * Configuation settings for the Freescale MCF5373 FireEngine board.
4  *
5  * Copyright (C) 2004-2007, 2012 Freescale Semiconductor, Inc.
6  * TsiChung Liew (Tsi-Chung.Liew@freescale.com)
7  */
8
9 /*
10  * board/config.h - configuration options, board specific
11  */
12
13 #ifndef _M5373EVB_H
14 #define _M5373EVB_H
15
16 #include <linux/stringify.h>
17
18 /*
19  * High Level Configuration Options
20  * (easy to change)
21  */
22
23 #define CONFIG_SYS_UART_PORT            (0)
24
25 #define CONFIG_WATCHDOG_TIMEOUT 3360    /* timeout in ms, max is 3.36 sec */
26
27 #define CONFIG_SYS_UNIFY_CACHE
28
29 #ifdef CONFIG_MCFFEC
30 #       define CONFIG_SYS_DISCOVER_PHY
31 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
32 #       ifndef CONFIG_SYS_DISCOVER_PHY
33 #               define FECDUPLEX        FULL
34 #               define FECSPEED         _100BASET
35 #       endif                   /* CONFIG_SYS_DISCOVER_PHY */
36 #endif
37
38 /* I2C */
39
40 #ifdef CONFIG_MCFFEC
41 #       define CONFIG_IPADDR    192.162.1.2
42 #       define CONFIG_NETMASK   255.255.255.0
43 #       define CONFIG_SERVERIP  192.162.1.1
44 #       define CONFIG_GATEWAYIP 192.162.1.1
45 #endif                          /* FEC_ENET */
46
47 #define CONFIG_HOSTNAME         "M5373EVB"
48 #define CONFIG_EXTRA_ENV_SETTINGS                                       \
49         "netdev=eth0\0"                 \
50         "loadaddr=" __stringify(CONFIG_SYS_LOAD_ADDR) "\0"      \
51         "u-boot=u-boot.bin\0"   \
52         "load=tftp ${loadaddr) ${u-boot}\0"     \
53         "upd=run load; run prog\0"      \
54         "prog=prot off 0 3ffff;"        \
55         "era 0 3ffff;"  \
56         "cp.b ${loadaddr} 0 ${filesize};"       \
57         "save\0"        \
58         ""
59
60 #define CONFIG_PRAM             512     /* 512 KB */
61
62 #define CONFIG_SYS_CLK                  80000000
63 #define CONFIG_SYS_CPU_CLK              CONFIG_SYS_CLK * 3
64
65 #define CONFIG_SYS_MBAR         0xFC000000
66
67 #define CONFIG_SYS_LATCH_ADDR           (CONFIG_SYS_CS1_BASE + 0x80000)
68
69 /*
70  * Low Level Configuration Settings
71  * (address mappings, register initial values, etc.)
72  * You should know what you are doing if you make changes here.
73  */
74 /*-----------------------------------------------------------------------
75  * Definitions for initial stack pointer and data area (in DPRAM)
76  */
77 #define CONFIG_SYS_INIT_RAM_ADDR        0x80000000
78 #define CONFIG_SYS_INIT_RAM_SIZE        0x8000  /* Size of used area in internal SRAM */
79 #define CONFIG_SYS_INIT_RAM_CTRL        0x221
80 #define CONFIG_SYS_GBL_DATA_OFFSET      ((CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE) - 0x10)
81 #define CONFIG_SYS_INIT_SP_OFFSET       CONFIG_SYS_GBL_DATA_OFFSET
82
83 /*-----------------------------------------------------------------------
84  * Start addresses for the final memory configuration
85  * (Set up by the startup code)
86  * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
87  */
88 #define CONFIG_SYS_SDRAM_BASE           0x40000000
89 #define CONFIG_SYS_SDRAM_SIZE           32      /* SDRAM size in MB */
90 #define CONFIG_SYS_SDRAM_CFG1           0x53722730
91 #define CONFIG_SYS_SDRAM_CFG2           0x56670000
92 #define CONFIG_SYS_SDRAM_CTRL           0xE1092000
93 #define CONFIG_SYS_SDRAM_EMOD           0x40010000
94 #define CONFIG_SYS_SDRAM_MODE           0x018D0000
95
96 #define CONFIG_SYS_MONITOR_LEN          (256 << 10)     /* Reserve 256 kB for Monitor */
97
98 /*
99  * For booting Linux, the board info and command line data
100  * have to be in the first 8 MB of memory, since this is
101  * the maximum mapped by the Linux kernel during initialization ??
102  */
103 #define CONFIG_SYS_BOOTMAPSZ            (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
104 #define CONFIG_SYS_BOOTM_LEN            (CONFIG_SYS_SDRAM_SIZE << 20)
105
106 /*-----------------------------------------------------------------------
107  * FLASH organization
108  */
109 #ifdef CONFIG_SYS_FLASH_CFI
110 #       define CONFIG_SYS_FLASH_SIZE            0x800000        /* Max size that the board might have */
111 #       define CONFIG_SYS_MAX_FLASH_SECT        137     /* max number of sectors on one chip */
112 #endif
113
114 #       define CONFIG_SYS_MAX_NAND_DEVICE       1
115 #       define CONFIG_SYS_NAND_BASE             CONFIG_SYS_CS2_BASE
116 #       define CONFIG_SYS_NAND_SIZE             1
117 #       define CONFIG_SYS_NAND_BASE_LIST        { CONFIG_SYS_NAND_BASE }
118 #       define NAND_ALLOW_ERASE_ALL     1
119
120 #define CONFIG_SYS_FLASH_BASE           CONFIG_SYS_CS0_BASE
121
122 /* Configuration for environment
123  * Environment is embedded in u-boot in the second sector of the flash
124  */
125
126 #define LDS_BOARD_TEXT \
127         . = DEFINED(env_offset) ? env_offset : .; \
128         env/embedded.o(.text*);
129
130 /*-----------------------------------------------------------------------
131  * Cache Configuration
132  */
133
134 #define ICACHE_STATUS                   (CONFIG_SYS_INIT_RAM_ADDR + \
135                                          CONFIG_SYS_INIT_RAM_SIZE - 8)
136 #define DCACHE_STATUS                   (CONFIG_SYS_INIT_RAM_ADDR + \
137                                          CONFIG_SYS_INIT_RAM_SIZE - 4)
138 #define CONFIG_SYS_ICACHE_INV           (CF_CACR_CINVA)
139 #define CONFIG_SYS_CACHE_ACR0           (CONFIG_SYS_SDRAM_BASE | \
140                                          CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
141                                          CF_ACR_EN | CF_ACR_SM_ALL)
142 #define CONFIG_SYS_CACHE_ICACR          (CF_CACR_EC | CF_CACR_CINVA | \
143                                          CF_CACR_DCM_P)
144
145 /*-----------------------------------------------------------------------
146  * Chipselect bank definitions
147  */
148 /*
149  * CS0 - NOR Flash 1, 2, 4, or 8MB
150  * CS1 - CompactFlash and registers
151  * CS2 - NAND Flash 16, 32, or 64MB
152  * CS3 - Available
153  * CS4 - Available
154  * CS5 - Available
155  */
156 #define CONFIG_SYS_CS0_BASE             0
157 #define CONFIG_SYS_CS0_MASK             0x007f0001
158 #define CONFIG_SYS_CS0_CTRL             0x00001fa0
159
160 #define CONFIG_SYS_CS1_BASE             0x10000000
161 #define CONFIG_SYS_CS1_MASK             0x001f0001
162 #define CONFIG_SYS_CS1_CTRL             0x002A3780
163
164 #define CONFIG_SYS_CS2_BASE             0x20000000
165 #define CONFIG_SYS_CS2_MASK             (16 << 20)
166 #define CONFIG_SYS_CS2_CTRL             0x00001f60
167
168 #endif                          /* _M5373EVB_H */