2 * Configuation settings for the Freescale MCF5329 FireEngine board.
4 * Copyright (C) 2004-2007 Freescale Semiconductor, Inc.
5 * TsiChung Liew (Tsi-Chung.Liew@freescale.com)
7 * SPDX-License-Identifier: GPL-2.0+
11 * board/config.h - configuration options, board specific
18 * High Level Configuration Options
22 #define CONFIG_MCFUART
23 #define CONFIG_SYS_UART_PORT (0)
24 #define CONFIG_BAUDRATE 115200
26 #undef CONFIG_WATCHDOG
27 #define CONFIG_WATCHDOG_TIMEOUT 5000 /* timeout in milliseconds, max timeout is 6.71sec */
32 #define CONFIG_BOOTP_BOOTFILESIZE
33 #define CONFIG_BOOTP_BOOTPATH
34 #define CONFIG_BOOTP_GATEWAY
35 #define CONFIG_BOOTP_HOSTNAME
37 /* Command line configuration */
38 #define CONFIG_CMD_CACHE
39 #define CONFIG_CMD_DHCP
40 #define CONFIG_CMD_I2C
41 #define CONFIG_CMD_MII
42 #define CONFIG_CMD_PCI
43 #define CONFIG_CMD_PING
44 #define CONFIG_CMD_REGINFO
50 # define CONFIG_MII_INIT 1
51 # define CONFIG_SYS_DISCOVER_PHY
52 # define CONFIG_SYS_RX_ETH_BUFFER 8
53 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
55 # define CONFIG_SYS_FEC0_PINMUX 0
56 # define CONFIG_SYS_FEC0_MIIBASE CONFIG_SYS_FEC0_IOBASE
57 # define MCFFEC_TOUT_LOOP 50000
58 /* If CONFIG_SYS_DISCOVER_PHY is not defined - hardcoded */
59 # ifndef CONFIG_SYS_DISCOVER_PHY
60 # define FECDUPLEX FULL
61 # define FECSPEED _100BASET
63 # ifndef CONFIG_SYS_FAULT_ECHO_LINK_DOWN
64 # define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
66 # endif /* CONFIG_SYS_DISCOVER_PHY */
74 #define CONFIG_SYS_I2C
75 #define CONFIG_SYS_i2C_FSL
76 #define CONFIG_SYS_FSL_I2C_SPEED 80000
77 #define CONFIG_SYS_FSL_I2C_SLAVE 0x7F
78 #define CONFIG_SYS_FSL_I2C_OFFSET 0x00000300
79 #define CONFIG_SYS_IMMR CONFIG_SYS_MBAR
80 #define CONFIG_SYS_I2C_PINMUX_REG (gpio->par_qspi)
81 #define CONFIG_SYS_I2C_PINMUX_CLR ~(GPIO_PAR_FECI2C_SCL_MASK | GPIO_PAR_FECI2C_SDA_MASK)
82 #define CONFIG_SYS_I2C_PINMUX_SET (GPIO_PAR_FECI2C_SCL_I2CSCL | GPIO_PAR_FECI2C_SDA_I2CSDA)
84 /* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
85 #define CONFIG_BOOTDELAY 1 /* autoboot after 5 seconds */
86 #define CONFIG_BOOTFILE "u-boot.bin"
88 # define CONFIG_IPADDR 192.162.1.2
89 # define CONFIG_NETMASK 255.255.255.0
90 # define CONFIG_SERVERIP 192.162.1.1
91 # define CONFIG_GATEWAYIP 192.162.1.1
94 #define CONFIG_HOSTNAME M5235EVB
95 #define CONFIG_EXTRA_ENV_SETTINGS \
98 "u-boot=u-boot.bin\0" \
99 "load=tftp ${loadaddr) ${u-boot}\0" \
100 "upd=run load; run prog\0" \
101 "prog=prot off ffe00000 ffe3ffff;" \
102 "era ffe00000 ffe3ffff;" \
103 "cp.b ${loadaddr} ffe00000 ${filesize};"\
107 #define CONFIG_PRAM 512 /* 512 KB */
108 #define CONFIG_SYS_LONGHELP /* undef to save memory */
110 #if defined(CONFIG_KGDB)
111 # define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buffer Size */
113 # define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */
116 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
117 #define CONFIG_SYS_MAXARGS 16 /* max number of command args */
118 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */
119 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE+0x20000)
121 #define CONFIG_SYS_CLK 75000000
122 #define CONFIG_SYS_CPU_CLK CONFIG_SYS_CLK * 2
124 #define CONFIG_SYS_MBAR 0x40000000
127 * Low Level Configuration Settings
128 * (address mappings, register initial values, etc.)
129 * You should know what you are doing if you make changes here.
131 /*-----------------------------------------------------------------------
132 * Definitions for initial stack pointer and data area (in DPRAM)
134 #define CONFIG_SYS_INIT_RAM_ADDR 0x20000000
135 #define CONFIG_SYS_INIT_RAM_SIZE 0x10000 /* Size of used area in internal SRAM */
136 #define CONFIG_SYS_INIT_RAM_CTRL 0x21
137 #define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE - 0x10)
138 #define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET
140 /*-----------------------------------------------------------------------
141 * Start addresses for the final memory configuration
142 * (Set up by the startup code)
143 * Please note that CONFIG_SYS_SDRAM_BASE _must_ start at 0
145 #define CONFIG_SYS_SDRAM_BASE 0x00000000
146 #define CONFIG_SYS_SDRAM_SIZE 16 /* SDRAM size in MB */
148 #define CONFIG_SYS_MEMTEST_START CONFIG_SYS_SDRAM_BASE + 0x400
149 #define CONFIG_SYS_MEMTEST_END ((CONFIG_SYS_SDRAM_SIZE - 3) << 20)
151 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE + 0x400)
152 #define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */
154 #define CONFIG_SYS_BOOTPARAMS_LEN 64*1024
155 #define CONFIG_SYS_MALLOC_LEN (128 << 10) /* Reserve 128 kB for malloc() */
158 * For booting Linux, the board info and command line data
159 * have to be in the first 8 MB of memory, since this is
160 * the maximum mapped by the Linux kernel during initialization ??
162 /* Initial Memory map for Linux */
163 #define CONFIG_SYS_BOOTMAPSZ (CONFIG_SYS_SDRAM_BASE + (CONFIG_SYS_SDRAM_SIZE << 20))
164 #define CONFIG_SYS_BOOTM_LEN (CONFIG_SYS_SDRAM_SIZE << 20)
166 /*-----------------------------------------------------------------------
169 #define CONFIG_SYS_FLASH_CFI
170 #ifdef CONFIG_SYS_FLASH_CFI
171 # define CONFIG_FLASH_CFI_DRIVER 1
172 # define CONFIG_SYS_FLASH_SIZE 0x800000 /* Max size that the board might have */
173 #ifdef NORFLASH_PS32BIT
174 # define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_32BIT
176 # define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT
178 # define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max number of memory banks */
179 # define CONFIG_SYS_MAX_FLASH_SECT 137 /* max number of sectors on one chip */
180 # define CONFIG_SYS_FLASH_PROTECTION /* "Real" (hardware) sectors protection */
183 #define CONFIG_SYS_FLASH_BASE (CONFIG_SYS_CS0_BASE)
185 /* Configuration for environment
186 * Environment is embedded in u-boot in the second sector of the flash
188 #define CONFIG_ENV_IS_IN_FLASH 1
190 #define LDS_BOARD_TEXT \
191 . = DEFINED(env_offset) ? env_offset : .; \
192 common/env_embedded.o (.text);
194 #ifdef NORFLASH_PS32BIT
195 # define CONFIG_ENV_OFFSET (0x8000)
196 # define CONFIG_ENV_SIZE 0x4000
197 # define CONFIG_ENV_SECT_SIZE 0x4000
199 # define CONFIG_ENV_OFFSET (0x4000)
200 # define CONFIG_ENV_SIZE 0x2000
201 # define CONFIG_ENV_SECT_SIZE 0x2000
204 /*-----------------------------------------------------------------------
205 * Cache Configuration
207 #define CONFIG_SYS_CACHELINE_SIZE 16
209 #define ICACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \
210 CONFIG_SYS_INIT_RAM_SIZE - 8)
211 #define DCACHE_STATUS (CONFIG_SYS_INIT_RAM_ADDR + \
212 CONFIG_SYS_INIT_RAM_SIZE - 4)
213 #define CONFIG_SYS_ICACHE_INV (CF_CACR_CINV)
214 #define CONFIG_SYS_CACHE_ACR0 (CONFIG_SYS_SDRAM_BASE | \
215 CF_ADDRMASK(CONFIG_SYS_SDRAM_SIZE) | \
216 CF_ACR_EN | CF_ACR_SM_ALL)
217 #define CONFIG_SYS_CACHE_ICACR (CF_CACR_CENB | CF_CACR_DISD | \
218 CF_CACR_CEIB | CF_CACR_DCM | \
221 /*-----------------------------------------------------------------------
222 * Chipselect bank definitions
225 * CS0 - NOR Flash 1, 2, 4, or 8MB
234 #ifdef NORFLASH_PS32BIT
235 # define CONFIG_SYS_CS0_BASE 0xFFC00000
236 # define CONFIG_SYS_CS0_MASK 0x003f0001
237 # define CONFIG_SYS_CS0_CTRL 0x00001D00
239 # define CONFIG_SYS_CS0_BASE 0xFFE00000
240 # define CONFIG_SYS_CS0_MASK 0x001f0001
241 # define CONFIG_SYS_CS0_CTRL 0x00001D80
244 #endif /* _M5329EVB_H */