2 * (C) Copyright 2005, Psyent Corporation <www.psyent.com>
3 * Scott McNutt <smcnutt@psyent.com>
4 * (C) Copyright 2010, Thomas Chou <thomas@wytron.com.tw>
6 * SPDX-License-Identifier: GPL-2.0+
15 #define CONFIG_DISPLAY_CPUINFO
16 #define CONFIG_DISPLAY_BOARDINFO_LATE
21 #define CONFIG_BAUDRATE 115200
22 #define CONFIG_SYS_CONSOLE_INFO_QUIET /* Suppress console info */
27 #define CONFIG_SYS_MAX_FLASH_BANKS 1
28 #define CONFIG_SYS_MAX_FLASH_SECT 1024
29 #define CONFIG_MTD_DEVICE
34 #define CONFIG_SYS_RX_ETH_BUFFER 0
35 #define CONFIG_CMD_MII
36 #define CONFIG_PHY_GIGE
37 #define CONFIG_SYS_FAULT_ECHO_LINK_DOWN
38 #define CONFIG_PHY_MARVELL
43 #define CONFIG_BOOTP_BOOTFILESIZE
44 #define CONFIG_BOOTP_BOOTPATH
45 #define CONFIG_BOOTP_GATEWAY
46 #define CONFIG_BOOTP_HOSTNAME
51 #define CONFIG_OF_LIBFDT
52 #define CONFIG_OF_BOARD_SETUP
56 * ENVIRONMENT -- Put environment in sector CONFIG_SYS_MONITOR_LEN above
57 * CONFIG_SYS_RESET_ADDR, since we assume the monitor is stored at the
58 * reset address, no? This will keep the environment in user region
59 * of flash. NOTE: the monitor length must be multiple of sector size
60 * (which is common practice).
62 #define CONFIG_ENV_IS_IN_FLASH
64 #define CONFIG_ENV_SIZE 0x10000 /* 64k, 1 sector */
65 #define CONFIG_ENV_OVERWRITE /* Serial change Ok */
66 #define CONFIG_ENV_ADDR 0xf4040000
70 * -Monitor at top of sdram.
71 * -The heap is placed below the monitor
72 * -The stack is placed below the heap (&grows down).
74 #define CONFIG_SYS_SDRAM_BASE 0xc8000000
75 #define CONFIG_SYS_SDRAM_SIZE 0x08000000
76 #define CONFIG_NR_DRAM_BANKS 1
77 #define CONFIG_MONITOR_IS_IN_RAM
78 #define CONFIG_SYS_MONITOR_LEN 0x40000 /* Reserve 256k */
79 #define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_SDRAM_BASE + \
80 CONFIG_SYS_SDRAM_SIZE - \
81 CONFIG_SYS_MONITOR_LEN)
82 #define CONFIG_SYS_MALLOC_LEN 0x20000
87 #define CONFIG_SYS_LONGHELP /* Provide extended help */
88 #define CONFIG_SYS_CBSIZE 256 /* Console I/O buf size */
89 #define CONFIG_SYS_MAXARGS 16 /* Max command args */
90 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Bootarg buf size */
91 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + \
92 sizeof(CONFIG_SYS_PROMPT) + \
93 16) /* Print buf size */
94 #define CONFIG_SYS_LOAD_ADDR CONFIG_SYS_SDRAM_BASE
95 #define CONFIG_SYS_MEMTEST_START CONFIG_SYS_SDRAM_BASE
96 #define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MONITOR_BASE - \
98 CONFIG_SYS_MALLOC_LEN - \
100 #define CONFIG_CMDLINE_EDITING
102 #endif /* __CONFIG_H */