3 * Wolfgang Denk, DENX Software Engineering, wd@denx.de.
5 * SPDX-License-Identifier: GPL-2.0+
9 * Most of the following information was derived from the document
10 * "Information Technology - AT Attachment-3 Interface (ATA-3)"
11 * which can be found at:
12 * http://www.dt.wdc.com/ata/ata-3/ata3r5v.zip
13 * ftp://poctok.iae.nsk.su/pub/asm/Documents/IDE/ATA3R5V.ZIP
14 * ftp://ftp.fee.vutbr.cz/pub/doc/io/ata/ata-3/ata3r5v.zip
22 /* Register addressing depends on the hardware design; for instance,
23 * 8-bit (register) and 16-bit (data) accesses might use different
24 * address spaces. This is implemented by the following definitions.
26 #ifndef CONFIG_SYS_ATA_STRIDE
27 #define CONFIG_SYS_ATA_STRIDE 1
30 #define ATA_IO_DATA(x) (CONFIG_SYS_ATA_DATA_OFFSET+((x) * CONFIG_SYS_ATA_STRIDE))
31 #define ATA_IO_REG(x) (CONFIG_SYS_ATA_REG_OFFSET +((x) * CONFIG_SYS_ATA_STRIDE))
32 #define ATA_IO_ALT(x) (CONFIG_SYS_ATA_ALT_OFFSET +((x) * CONFIG_SYS_ATA_STRIDE))
35 * I/O Register Descriptions
37 #define ATA_DATA_REG ATA_IO_DATA(0)
38 #define ATA_ERROR_REG ATA_IO_REG(1)
39 #define ATA_SECT_CNT ATA_IO_REG(2)
40 #define ATA_SECT_NUM ATA_IO_REG(3)
41 #define ATA_CYL_LOW ATA_IO_REG(4)
42 #define ATA_CYL_HIGH ATA_IO_REG(5)
43 #define ATA_DEV_HD ATA_IO_REG(6)
44 #define ATA_COMMAND ATA_IO_REG(7)
45 #define ATA_DATA_EVEN ATA_IO_REG(8)
46 #define ATA_DATA_ODD ATA_IO_REG(9)
47 #define ATA_STATUS ATA_COMMAND
48 #define ATA_DEV_CTL ATA_IO_ALT(6)
49 #define ATA_LBA_LOW ATA_SECT_NUM
50 #define ATA_LBA_MID ATA_CYL_LOW
51 #define ATA_LBA_HIGH ATA_CYL_HIGH
52 #define ATA_LBA_SEL ATA_DEV_CTL
55 * Status register bits
57 #define ATA_STAT_BUSY 0x80 /* Device Busy */
58 #define ATA_STAT_READY 0x40 /* Device Ready */
59 #define ATA_STAT_FAULT 0x20 /* Device Fault */
60 #define ATA_STAT_SEEK 0x10 /* Device Seek Complete */
61 #define ATA_STAT_DRQ 0x08 /* Data Request (ready) */
62 #define ATA_STAT_CORR 0x04 /* Corrected Data Error */
63 #define ATA_STAT_INDEX 0x02 /* Vendor specific */
64 #define ATA_STAT_ERR 0x01 /* Error */
67 * Device / Head Register Bits
70 #define ATA_DEVICE(x) ((x & 1)<<4)
71 #endif /* ATA_DEVICE */
75 * ATA Commands (only mandatory commands listed here)
77 #define ATA_CMD_READ 0x20 /* Read Sectors (with retries) */
78 #define ATA_CMD_READN 0x21 /* Read Sectors ( no retries) */
79 #define ATA_CMD_WRITE 0x30 /* Write Sectores (with retries)*/
80 #define ATA_CMD_WRITEN 0x31 /* Write Sectors ( no retries)*/
81 #define ATA_CMD_VRFY 0x40 /* Read Verify (with retries) */
82 #define ATA_CMD_VRFYN 0x41 /* Read verify ( no retries) */
83 #define ATA_CMD_SEEK 0x70 /* Seek */
84 #define ATA_CMD_DIAG 0x90 /* Execute Device Diagnostic */
85 #define ATA_CMD_INIT 0x91 /* Initialize Device Parameters */
86 #define ATA_CMD_RD_MULT 0xC4 /* Read Multiple */
87 #define ATA_CMD_WR_MULT 0xC5 /* Write Multiple */
88 #define ATA_CMD_SETMULT 0xC6 /* Set Multiple Mode */
89 #define ATA_CMD_RD_DMA 0xC8 /* Read DMA (with retries) */
90 #define ATA_CMD_RD_DMAN 0xC9 /* Read DMS ( no retries) */
91 #define ATA_CMD_WR_DMA 0xCA /* Write DMA (with retries) */
92 #define ATA_CMD_WR_DMAN 0xCB /* Write DMA ( no retires) */
93 #define ATA_CMD_IDENT 0xEC /* Identify Device */
94 #define ATA_CMD_SETF 0xEF /* Set Features */
95 #define ATA_CMD_CHK_PWR 0xE5 /* Check Power Mode */
97 #define ATA_CMD_READ_EXT 0x24 /* Read Sectors (with retries) with 48bit addressing */
98 #define ATA_CMD_WRITE_EXT 0x34 /* Write Sectores (with retries) with 48bit addressing */
99 #define ATA_CMD_VRFY_EXT 0x42 /* Read Verify (with retries) with 48bit addressing */
101 #define ATA_CMD_FLUSH 0xE7 /* Flush drive cache */
102 #define ATA_CMD_FLUSH_EXT 0xEA /* Flush drive cache, with 48bit addressing */
107 #define ATAPI_CMD_IDENT 0xA1 /* Identify AT Atachment Packed Interface Device */
108 #define ATAPI_CMD_PACKET 0xA0 /* Packed Command */
111 #define ATAPI_CMD_INQUIRY 0x12
112 #define ATAPI_CMD_REQ_SENSE 0x03
113 #define ATAPI_CMD_READ_CAP 0x25
114 #define ATAPI_CMD_START_STOP 0x1B
115 #define ATAPI_CMD_READ_12 0xA8
118 #define ATA_GET_ERR() inb(ATA_STATUS)
119 #define ATA_GET_STAT() inb(ATA_STATUS)
120 #define ATA_OK_STAT(stat,good,bad) (((stat)&((good)|(bad)))==(good))
121 #define ATA_BAD_R_STAT (ATA_STAT_BUSY | ATA_STAT_ERR)
122 #define ATA_BAD_W_STAT (ATA_BAD_R_STAT | ATA_STAT_FAULT)
123 #define ATA_BAD_STAT (ATA_BAD_R_STAT | ATA_STAT_DRQ)
124 #define ATA_DRIVE_READY (ATA_READY_STAT | ATA_STAT_SEEK)
125 #define ATA_DATA_READY (ATA_STAT_DRQ)
127 #define ATA_BLOCKSIZE 512 /* bytes */
128 #define ATA_BLOCKSHIFT 9 /* 2 ^ ATA_BLOCKSIZESHIFT = 512 */
129 #define ATA_SECTORWORDS (512 / sizeof(unsigned long))
131 #ifndef ATA_RESET_TIME
132 #define ATA_RESET_TIME 60 /* spec allows up to 31 seconds */
135 /* ------------------------------------------------------------------------- */
138 * structure returned by ATA_CMD_IDENT, as per ANSI ATA2 rev.2f spec
140 typedef struct hd_driveid {
141 unsigned short config; /* lots of obsolete bit flags */
142 unsigned short cyls; /* "physical" cyls */
143 unsigned short reserved2; /* reserved (word 2) */
144 unsigned short heads; /* "physical" heads */
145 unsigned short track_bytes; /* unformatted bytes per track */
146 unsigned short sector_bytes; /* unformatted bytes per sector */
147 unsigned short sectors; /* "physical" sectors per track */
148 unsigned short vendor0; /* vendor unique */
149 unsigned short vendor1; /* vendor unique */
150 unsigned short vendor2; /* vendor unique */
151 unsigned char serial_no[20]; /* 0 = not_specified */
152 unsigned short buf_type;
153 unsigned short buf_size; /* 512 byte increments; 0 = not_specified */
154 unsigned short ecc_bytes; /* for r/w long cmds; 0 = not_specified */
155 unsigned char fw_rev[8]; /* 0 = not_specified */
156 unsigned char model[40]; /* 0 = not_specified */
157 unsigned char max_multsect; /* 0=not_implemented */
158 unsigned char vendor3; /* vendor unique */
159 unsigned short dword_io; /* 0=not_implemented; 1=implemented */
160 unsigned char vendor4; /* vendor unique */
161 unsigned char capability; /* bits 0:DMA 1:LBA 2:IORDYsw 3:IORDYsup*/
162 unsigned short reserved50; /* reserved (word 50) */
163 unsigned char vendor5; /* vendor unique */
164 unsigned char tPIO; /* 0=slow, 1=medium, 2=fast */
165 unsigned char vendor6; /* vendor unique */
166 unsigned char tDMA; /* 0=slow, 1=medium, 2=fast */
167 unsigned short field_valid; /* bits 0:cur_ok 1:eide_ok */
168 unsigned short cur_cyls; /* logical cylinders */
169 unsigned short cur_heads; /* logical heads */
170 unsigned short cur_sectors; /* logical sectors per track */
171 unsigned short cur_capacity0; /* logical total sectors on drive */
172 unsigned short cur_capacity1; /* (2 words, misaligned int) */
173 unsigned char multsect; /* current multiple sector count */
174 unsigned char multsect_valid; /* when (bit0==1) multsect is ok */
175 unsigned int lba_capacity; /* total number of sectors */
176 unsigned short dma_1word; /* single-word dma info */
177 unsigned short dma_mword; /* multiple-word dma info */
178 unsigned short eide_pio_modes; /* bits 0:mode3 1:mode4 */
179 unsigned short eide_dma_min; /* min mword dma cycle time (ns) */
180 unsigned short eide_dma_time; /* recommended mword dma cycle time (ns) */
181 unsigned short eide_pio; /* min cycle time (ns), no IORDY */
182 unsigned short eide_pio_iordy; /* min cycle time (ns), with IORDY */
183 unsigned short words69_70[2]; /* reserved words 69-70 */
184 unsigned short words71_74[4]; /* reserved words 71-74 */
185 unsigned short queue_depth; /* */
186 unsigned short words76_79[4]; /* reserved words 76-79 */
187 unsigned short major_rev_num; /* */
188 unsigned short minor_rev_num; /* */
189 unsigned short command_set_1; /* bits 0:Smart 1:Security 2:Removable 3:PM */
190 unsigned short command_set_2; /* bits 14:Smart Enabled 13:0 zero 10:lba48 support*/
191 unsigned short cfsse; /* command set-feature supported extensions */
192 unsigned short cfs_enable_1; /* command set-feature enabled */
193 unsigned short cfs_enable_2; /* command set-feature enabled */
194 unsigned short csf_default; /* command set-feature default */
195 unsigned short dma_ultra; /* */
196 unsigned short word89; /* reserved (word 89) */
197 unsigned short word90; /* reserved (word 90) */
198 unsigned short CurAPMvalues; /* current APM values */
199 unsigned short word92; /* reserved (word 92) */
200 unsigned short hw_config; /* hardware config */
201 unsigned short words94_99[6];/* reserved words 94-99 */
202 /*unsigned long long lba48_capacity; /--* 4 16bit values containing lba 48 total number of sectors */
203 unsigned short lba48_capacity[4]; /* 4 16bit values containing lba 48 total number of sectors */
204 unsigned short words104_125[22];/* reserved words 104-125 */
205 unsigned short last_lun; /* reserved (word 126) */
206 unsigned short word127; /* reserved (word 127) */
207 unsigned short dlf; /* device lock function
209 * 8 security level 1:max 0:high
218 unsigned short csfo; /* current set features options
225 unsigned short words130_155[26];/* reserved vendor words 130-155 */
226 unsigned short word156;
227 unsigned short words157_159[3];/* reserved vendor words 157-159 */
228 unsigned short words160_162[3];/* reserved words 160-162 */
229 unsigned short cf_advanced_caps;
230 unsigned short words164_255[92];/* reserved words 164-255 */
235 * PIO Mode Configuration
237 * See ATA-3 (AT Attachment-3 Interface) documentation, Figure 14 / Table 21
241 unsigned int t_setup; /* Setup Time in [ns] or clocks */
242 unsigned int t_length; /* Length Time in [ns] or clocks */
243 unsigned int t_hold; /* Hold Time in [ns] or clocks */
247 #define IDE_MAX_PIO_MODE 4 /* max suppurted PIO mode */
249 /* ------------------------------------------------------------------------- */