1 // SPDX-License-Identifier: GPL-2.0-only
3 * GPIO driver for EXAR XRA1403 16-bit GPIO expander
5 * Copyright (c) 2017, General Electric Company
8 #include <linux/bitops.h>
9 #include <linux/gpio/driver.h>
10 #include <linux/kernel.h>
11 #include <linux/module.h>
12 #include <linux/mutex.h>
13 #include <linux/of_device.h>
14 #include <linux/of_gpio.h>
15 #include <linux/seq_file.h>
16 #include <linux/spi/spi.h>
17 #include <linux/regmap.h>
19 /* XRA1403 registers */
20 #define XRA_GSR 0x00 /* GPIO State */
21 #define XRA_OCR 0x02 /* Output Control */
22 #define XRA_PIR 0x04 /* Input Polarity Inversion */
23 #define XRA_GCR 0x06 /* GPIO Configuration */
24 #define XRA_PUR 0x08 /* Input Internal Pull-up Resistor Enable/Disable */
25 #define XRA_IER 0x0A /* Input Interrupt Enable */
26 #define XRA_TSCR 0x0C /* Output Three-State Control */
27 #define XRA_ISR 0x0E /* Input Interrupt Status */
28 #define XRA_REIR 0x10 /* Input Rising Edge Interrupt Enable */
29 #define XRA_FEIR 0x12 /* Input Falling Edge Interrupt Enable */
30 #define XRA_IFR 0x14 /* Input Filter Enable/Disable */
31 #define XRA_LAST 0x15 /* Bounds */
34 struct gpio_chip chip;
35 struct regmap *regmap;
38 static const struct regmap_config xra1403_regmap_cfg = {
43 .max_register = XRA_LAST,
46 static unsigned int to_reg(unsigned int reg, unsigned int offset)
48 return reg + (offset > 7);
51 static int xra1403_direction_input(struct gpio_chip *chip, unsigned int offset)
53 struct xra1403 *xra = gpiochip_get_data(chip);
55 return regmap_update_bits(xra->regmap, to_reg(XRA_GCR, offset),
56 BIT(offset % 8), BIT(offset % 8));
59 static int xra1403_direction_output(struct gpio_chip *chip, unsigned int offset,
63 struct xra1403 *xra = gpiochip_get_data(chip);
65 ret = regmap_update_bits(xra->regmap, to_reg(XRA_GCR, offset),
70 ret = regmap_update_bits(xra->regmap, to_reg(XRA_OCR, offset),
71 BIT(offset % 8), value ? BIT(offset % 8) : 0);
76 static int xra1403_get_direction(struct gpio_chip *chip, unsigned int offset)
80 struct xra1403 *xra = gpiochip_get_data(chip);
82 ret = regmap_read(xra->regmap, to_reg(XRA_GCR, offset), &val);
86 if (val & BIT(offset % 8))
87 return GPIO_LINE_DIRECTION_IN;
89 return GPIO_LINE_DIRECTION_OUT;
92 static int xra1403_get(struct gpio_chip *chip, unsigned int offset)
96 struct xra1403 *xra = gpiochip_get_data(chip);
98 ret = regmap_read(xra->regmap, to_reg(XRA_GSR, offset), &val);
102 return !!(val & BIT(offset % 8));
105 static void xra1403_set(struct gpio_chip *chip, unsigned int offset, int value)
108 struct xra1403 *xra = gpiochip_get_data(chip);
110 ret = regmap_update_bits(xra->regmap, to_reg(XRA_OCR, offset),
111 BIT(offset % 8), value ? BIT(offset % 8) : 0);
113 dev_err(chip->parent, "Failed to set pin: %d, ret: %d\n",
117 #ifdef CONFIG_DEBUG_FS
118 static void xra1403_dbg_show(struct seq_file *s, struct gpio_chip *chip)
121 struct xra1403 *xra = gpiochip_get_data(chip);
128 seq_puts(s, "xra reg:");
129 for (reg = 0; reg <= XRA_LAST; reg++)
130 seq_printf(s, " %2.2x", reg);
131 seq_puts(s, "\n value:");
132 for (reg = 0; reg < XRA_LAST; reg++) {
133 regmap_read(xra->regmap, reg, &value[reg]);
134 seq_printf(s, " %2.2x", value[reg]);
138 gcr = value[XRA_GCR + 1] << 8 | value[XRA_GCR];
139 gsr = value[XRA_GSR + 1] << 8 | value[XRA_GSR];
140 for_each_requested_gpio(chip, i, label) {
141 seq_printf(s, " gpio-%-3d (%-12s) %s %s\n",
142 chip->base + i, label,
143 (gcr & BIT(i)) ? "in" : "out",
144 (gsr & BIT(i)) ? "hi" : "lo");
148 #define xra1403_dbg_show NULL
151 static int xra1403_probe(struct spi_device *spi)
154 struct gpio_desc *reset_gpio;
157 xra = devm_kzalloc(&spi->dev, sizeof(*xra), GFP_KERNEL);
161 /* bring the chip out of reset if reset pin is provided*/
162 reset_gpio = devm_gpiod_get_optional(&spi->dev, "reset", GPIOD_OUT_LOW);
163 if (IS_ERR(reset_gpio))
164 dev_warn(&spi->dev, "Could not get reset-gpios\n");
166 xra->chip.direction_input = xra1403_direction_input;
167 xra->chip.direction_output = xra1403_direction_output;
168 xra->chip.get_direction = xra1403_get_direction;
169 xra->chip.get = xra1403_get;
170 xra->chip.set = xra1403_set;
172 xra->chip.dbg_show = xra1403_dbg_show;
174 xra->chip.ngpio = 16;
175 xra->chip.label = "xra1403";
178 xra->chip.can_sleep = true;
179 xra->chip.parent = &spi->dev;
180 xra->chip.owner = THIS_MODULE;
182 xra->regmap = devm_regmap_init_spi(spi, &xra1403_regmap_cfg);
183 if (IS_ERR(xra->regmap)) {
184 ret = PTR_ERR(xra->regmap);
185 dev_err(&spi->dev, "Failed to allocate regmap: %d\n", ret);
189 return devm_gpiochip_add_data(&spi->dev, &xra->chip, xra);
192 static const struct spi_device_id xra1403_ids[] = {
196 MODULE_DEVICE_TABLE(spi, xra1403_ids);
198 static const struct of_device_id xra1403_spi_of_match[] = {
199 { .compatible = "exar,xra1403" },
202 MODULE_DEVICE_TABLE(of, xra1403_spi_of_match);
204 static struct spi_driver xra1403_driver = {
205 .probe = xra1403_probe,
206 .id_table = xra1403_ids,
209 .of_match_table = of_match_ptr(xra1403_spi_of_match),
213 module_spi_driver(xra1403_driver);
215 MODULE_AUTHOR("Nandor Han <nandor.han@ge.com>");
216 MODULE_AUTHOR("Semi Malinen <semi.malinen@ge.com>");
217 MODULE_DESCRIPTION("GPIO expander driver for EXAR XRA1403");
218 MODULE_LICENSE("GPL v2");