binman: Update fit to move node reading into the ReadNode() method
[platform/kernel/u-boot.git] / configs / ls1046aqds_tfa_defconfig
1 CONFIG_ARM=y
2 CONFIG_TARGET_LS1046AQDS=y
3 CONFIG_TFABOOT=y
4 CONFIG_SYS_TEXT_BASE=0x82000000
5 CONFIG_SYS_MALLOC_LEN=0x102000
6 CONFIG_NR_DRAM_BANKS=2
7 CONFIG_SYS_MEMTEST_START=0x80000000
8 CONFIG_SYS_MEMTEST_END=0x9fffffff
9 CONFIG_ENV_SIZE=0x2000
10 CONFIG_ENV_OFFSET=0x500000
11 CONFIG_ENV_SECT_SIZE=0x20000
12 CONFIG_SYS_I2C_MXC_I2C1=y
13 CONFIG_SYS_I2C_MXC_I2C2=y
14 CONFIG_SYS_I2C_MXC_I2C3=y
15 CONFIG_SYS_I2C_MXC_I2C4=y
16 CONFIG_DM_GPIO=y
17 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-qds-duart"
18 CONFIG_FSL_USE_PCA9547_MUX=y
19 CONFIG_VID=y
20 CONFIG_VID_FLS_ENV="ls1046aqds_vdd_mv"
21 CONFIG_VOL_MONITOR_INA220=y
22 CONFIG_VOL_MONITOR_IR36021_SET=y
23 CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
24 CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
25 CONFIG_AHCI=y
26 CONFIG_DISTRO_DEFAULTS=y
27 CONFIG_REMAKE_ELF=y
28 CONFIG_MP=y
29 CONFIG_FIT_VERBOSE=y
30 CONFIG_OF_BOARD_SETUP=y
31 CONFIG_DYNAMIC_SYS_CLK_FREQ=y
32 CONFIG_BOOTDELAY=10
33 CONFIG_USE_BOOTARGS=y
34 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:4m(nand_uboot),36m(nand_kernel),472m(nand_free);spi0.0:2m(uboot),14m(free)"
35 # CONFIG_USE_BOOTCOMMAND is not set
36 CONFIG_MISC_INIT_R=y
37 CONFIG_CMD_BOOTZ=y
38 CONFIG_CMD_IMLS=y
39 CONFIG_CMD_GREPENV=y
40 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
41 CONFIG_CMD_MEMINFO=y
42 CONFIG_CMD_MEMTEST=y
43 CONFIG_CMD_GPIO=y
44 CONFIG_CMD_GPT=y
45 CONFIG_CMD_I2C=y
46 CONFIG_CMD_MMC=y
47 CONFIG_CMD_NAND=y
48 CONFIG_CMD_PCI=y
49 CONFIG_CMD_USB=y
50 CONFIG_CMD_CACHE=y
51 CONFIG_MTDPARTS_DEFAULT="mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:4m(nand_uboot),36m(nand_kernel),472m(nand_free);spi0.0:2m(uboot),14m(free)"
52 CONFIG_OF_CONTROL=y
53 CONFIG_ENV_OVERWRITE=y
54 CONFIG_ENV_IS_IN_FLASH=y
55 CONFIG_ENV_IS_IN_MMC=y
56 CONFIG_ENV_IS_IN_NAND=y
57 CONFIG_ENV_IS_IN_SPI_FLASH=y
58 CONFIG_ENV_SPI_BUS=0
59 CONFIG_ENV_ADDR=0x60500000
60 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
61 CONFIG_DM=y
62 CONFIG_SATA=y
63 CONFIG_SATA_CEVA=y
64 CONFIG_FSL_CAAM=y
65 CONFIG_DYNAMIC_DDR_CLK_FREQ=y
66 CONFIG_DDR_ECC=y
67 CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
68 CONFIG_MPC8XXX_GPIO=y
69 CONFIG_DM_I2C=y
70 CONFIG_SYS_I2C_EARLY_INIT=y
71 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
72 CONFIG_SYS_I2C_EEPROM_ADDR=0x57
73 CONFIG_FSL_ESDHC=y
74 CONFIG_MTD=y
75 CONFIG_MTD_NOR_FLASH=y
76 CONFIG_FLASH_CFI_DRIVER=y
77 CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS=y
78 CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
79 CONFIG_SYS_FLASH_CFI=y
80 CONFIG_SYS_MAX_FLASH_BANKS=2
81 CONFIG_MTD_RAW_NAND=y
82 CONFIG_NAND_FSL_IFC=y
83 CONFIG_SYS_NAND_ONFI_DETECTION=y
84 CONFIG_SF_DEFAULT_BUS=1
85 # CONFIG_SPI_FLASH_BAR is not set
86 CONFIG_SPI_FLASH_EON=y
87 CONFIG_SPI_FLASH_SPANSION=y
88 CONFIG_SPI_FLASH_STMICRO=y
89 CONFIG_SPI_FLASH_SST=y
90 CONFIG_PHYLIB=y
91 CONFIG_PHYLIB_10G=y
92 CONFIG_PHY_REALTEK=y
93 CONFIG_PHY_VITESSE=y
94 CONFIG_E1000=y
95 CONFIG_FMAN_ENET=y
96 CONFIG_SYS_FMAN_FW_ADDR=0x900000
97 CONFIG_NVME_PCI=y
98 CONFIG_PCI=y
99 CONFIG_DM_PCI_COMPAT=y
100 CONFIG_PCIE_LAYERSCAPE_RC=y
101 CONFIG_PCIE_LAYERSCAPE_EP=y
102 CONFIG_DM_SCSI=y
103 CONFIG_SYS_NS16550=y
104 CONFIG_SPI=y
105 CONFIG_DM_SPI=y
106 CONFIG_FSL_DSPI=y
107 CONFIG_FSL_QSPI=y
108 CONFIG_USB=y
109 CONFIG_USB_XHCI_HCD=y
110 CONFIG_USB_XHCI_DWC3=y