2 CONFIG_COUNTER_FREQUENCY=25000000
3 CONFIG_TARGET_LS1046AFRWY=y
5 CONFIG_SYS_TEXT_BASE=0x82000000
6 CONFIG_SYS_MALLOC_LEN=0x102000
9 CONFIG_ENV_OFFSET=0x500000
10 CONFIG_ENV_SECT_SIZE=0x40000
12 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1046a-frwy"
13 CONFIG_QSPI_AHB_INIT=y
14 CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
15 CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
16 CONFIG_ENV_ADDR=0x40500000
18 CONFIG_LAYERSCAPE_NS_ACCESS=y
22 CONFIG_FSL_USE_PCA9547_MUX=y
23 CONFIG_DISTRO_DEFAULTS=y
27 CONFIG_OF_BOARD_SETUP=y
30 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=1550000.spi:1m(rcw),15m(u-boot),48m(kernel.itb);7e800000.flash:16m(nand_uboot),48m(nand_kernel),448m(nand_free)"
31 CONFIG_ARCH_MISC_INIT=y
35 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
43 CONFIG_MTDPARTS_DEFAULT="mtdparts=1550000.spi:1m(rcw),15m(u-boot),48m(kernel.itb);7e800000.flash:16m(nand_uboot),48m(nand_kernel),448m(nand_free)"
45 CONFIG_ENV_OVERWRITE=y
46 CONFIG_ENV_IS_IN_MMC=y
47 CONFIG_ENV_IS_IN_SPI_FLASH=y
48 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
50 CONFIG_ETHPRIME="FM1@DTSEC3"
55 # CONFIG_DDR_SPD is not set
58 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
59 CONFIG_SYS_I2C_EEPROM_ADDR=0x52
64 CONFIG_SYS_NAND_ONFI_DETECTION=y
65 # CONFIG_SPI_FLASH_BAR is not set
66 CONFIG_SPI_FLASH_STMICRO=y
67 # CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
73 CONFIG_SYS_FMAN_FW_ADDR=0x900000
76 CONFIG_DM_PCI_COMPAT=y
77 CONFIG_PCIE_LAYERSCAPE_RC=y
78 CONFIG_PCIE_LAYERSCAPE_EP=y
86 CONFIG_USB_XHCI_DWC3=y
87 CONFIG_USB_HOST_ETHER=y
88 CONFIG_USB_ETHER_ASIX=y
89 CONFIG_USB_ETHER_ASIX88179=y
90 CONFIG_USB_ETHER_RTL8152=y