binman: Update fit to move node reading into the ReadNode() method
[platform/kernel/u-boot.git] / configs / ls1043ardb_sdcard_defconfig
1 CONFIG_ARM=y
2 CONFIG_TARGET_LS1043ARDB=y
3 CONFIG_SYS_TEXT_BASE=0x82000000
4 CONFIG_SYS_MALLOC_LEN=0x102000
5 CONFIG_SPL_LIBCOMMON_SUPPORT=y
6 CONFIG_SPL_LIBGENERIC_SUPPORT=y
7 CONFIG_NR_DRAM_BANKS=2
8 CONFIG_ENV_SIZE=0x2000
9 CONFIG_ENV_OFFSET=0x300000
10 CONFIG_SYS_I2C_MXC_I2C1=y
11 CONFIG_SYS_I2C_MXC_I2C2=y
12 CONFIG_SYS_I2C_MXC_I2C3=y
13 CONFIG_SYS_I2C_MXC_I2C4=y
14 CONFIG_DM_GPIO=y
15 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1043a-rdb"
16 CONFIG_SPL_TEXT_BASE=0x10000000
17 CONFIG_FSL_LS_PPA=y
18 CONFIG_SPL_MMC=y
19 CONFIG_SPL_SERIAL=y
20 CONFIG_SPL_DRIVERS_MISC=y
21 CONFIG_SPL=y
22 CONFIG_DISTRO_DEFAULTS=y
23 CONFIG_REMAKE_ELF=y
24 CONFIG_MP=y
25 CONFIG_FIT_VERBOSE=y
26 CONFIG_OF_BOARD_SETUP=y
27 CONFIG_RAMBOOT_PBL=y
28 CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1043ardb/ls1043ardb_pbi.cfg"
29 CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1043ardb/ls1043ardb_rcw_sd.cfg"
30 CONFIG_SD_BOOT=y
31 CONFIG_BOOTDELAY=10
32 CONFIG_USE_BOOTARGS=y
33 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:1m(nand_uboot),1m(nand_uboot_env),20m(nand_fit);spi0.0:1m(uboot),5m(kernel),1m(dtb),9m(file_system)"
34 CONFIG_BOOTCOMMAND="run distro_bootcmd; run sd_bootcmd; env exists secureboot && esbc_halt;"
35 CONFIG_MISC_INIT_R=y
36 CONFIG_SPL_FSL_PBL=y
37 CONFIG_SPL_BOARD_INIT=y
38 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
39 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xf0
40 CONFIG_SPL_ENV_SUPPORT=y
41 CONFIG_SPL_MPC8XXX_INIT_DDR=y
42 CONFIG_SPL_WATCHDOG=y
43 CONFIG_CMD_IMLS=y
44 CONFIG_CMD_SPL=y
45 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
46 CONFIG_CMD_DM=y
47 CONFIG_CMD_GPIO=y
48 CONFIG_CMD_GPT=y
49 CONFIG_CMD_I2C=y
50 CONFIG_CMD_MMC=y
51 CONFIG_CMD_NAND=y
52 CONFIG_CMD_USB=y
53 CONFIG_CMD_CACHE=y
54 CONFIG_MTDPARTS_DEFAULT="mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:1m(nand_uboot),1m(nand_uboot_env),20m(nand_fit);spi0.0:1m(uboot),5m(kernel),1m(dtb),9m(file_system)"
55 # CONFIG_SPL_EFI_PARTITION is not set
56 CONFIG_OF_CONTROL=y
57 CONFIG_ENV_OVERWRITE=y
58 CONFIG_ENV_IS_IN_MMC=y
59 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
60 CONFIG_DM=y
61 CONFIG_FSL_CAAM=y
62 CONFIG_MPC8XXX_GPIO=y
63 CONFIG_DM_I2C=y
64 CONFIG_SPL_SYS_I2C_LEGACY=y
65 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
66 CONFIG_SYS_I2C_EEPROM_ADDR=0x53
67 CONFIG_FSL_ESDHC=y
68 CONFIG_MTD=y
69 CONFIG_MTD_NOR_FLASH=y
70 CONFIG_FLASH_CFI_DRIVER=y
71 CONFIG_CFI_FLASH_USE_WEAK_ACCESSORS=y
72 CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
73 CONFIG_SYS_FLASH_CFI=y
74 CONFIG_MTD_RAW_NAND=y
75 CONFIG_NAND_FSL_IFC=y
76 CONFIG_SYS_NAND_ONFI_DETECTION=y
77 CONFIG_SF_DEFAULT_BUS=1
78 CONFIG_SPI_FLASH_EON=y
79 CONFIG_SPI_FLASH_STMICRO=y
80 CONFIG_SPI_FLASH_SST=y
81 CONFIG_PHYLIB=y
82 CONFIG_PHY_AQUANTIA=y
83 CONFIG_PHY_REALTEK=y
84 CONFIG_PHY_VITESSE=y
85 CONFIG_DM_ETH=y
86 CONFIG_DM_MDIO=y
87 CONFIG_E1000=y
88 CONFIG_FMAN_ENET=y
89 CONFIG_SYS_FMAN_FW_ADDR=0x900000
90 CONFIG_NVME_PCI=y
91 CONFIG_PCI=y
92 CONFIG_PCIE_LAYERSCAPE_RC=y
93 CONFIG_SYS_QE_FW_ADDR=0x940000
94 CONFIG_SYS_QE_FMAN_FW_IN_MMC=y
95 CONFIG_SYS_NS16550=y
96 CONFIG_SPI=y
97 CONFIG_DM_SPI=y
98 CONFIG_USB=y
99 CONFIG_USB_XHCI_HCD=y
100 CONFIG_USB_XHCI_DWC3=y
101 # CONFIG_SPL_USE_TINY_PRINTF is not set
102 CONFIG_EFI_LOADER_BOUNCE_BUFFER=y