boards: siemens: iot2050: Re-enable bootstage reporting
[platform/kernel/u-boot.git] / configs / ls1043aqds_nand_defconfig
1 CONFIG_ARM=y
2 CONFIG_TARGET_LS1043AQDS=y
3 CONFIG_SYS_TEXT_BASE=0x82000000
4 CONFIG_SYS_MALLOC_LEN=0x102000
5 CONFIG_SPL_LIBCOMMON_SUPPORT=y
6 CONFIG_SPL_LIBGENERIC_SUPPORT=y
7 CONFIG_NR_DRAM_BANKS=2
8 CONFIG_SYS_MEMTEST_START=0x80000000
9 CONFIG_SYS_MEMTEST_END=0x9fffffff
10 CONFIG_ENV_SIZE=0x2000
11 CONFIG_ENV_OFFSET=0x300000
12 CONFIG_SYS_I2C_MXC_I2C1=y
13 CONFIG_SYS_I2C_MXC_I2C2=y
14 CONFIG_SYS_I2C_MXC_I2C3=y
15 CONFIG_SYS_I2C_MXC_I2C4=y
16 CONFIG_DM_GPIO=y
17 CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1043a-qds-duart"
18 CONFIG_SPL_TEXT_BASE=0x10000000
19 CONFIG_FSL_USE_PCA9547_MUX=y
20 CONFIG_FSL_LS_PPA=y
21 CONFIG_SPL_SERIAL=y
22 CONFIG_SPL_DRIVERS_MISC=y
23 CONFIG_SPL=y
24 CONFIG_AHCI=y
25 CONFIG_DISTRO_DEFAULTS=y
26 CONFIG_FIT_VERBOSE=y
27 CONFIG_OF_BOARD_SETUP=y
28 CONFIG_SYS_EXTRA_OPTIONS="NAND_BOOT"
29 CONFIG_RAMBOOT_PBL=y
30 CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1043aqds/ls1043aqds_pbi.cfg"
31 CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1043aqds/ls1043aqds_rcw_nand.cfg"
32 CONFIG_NAND_BOOT=y
33 CONFIG_BOOTDELAY=10
34 CONFIG_USE_BOOTARGS=y
35 CONFIG_BOOTARGS="console=ttyS0,115200 root=/dev/ram0 earlycon=uart8250,mmio,0x21c0500 mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:1m(nand_uboot),1m(nand_uboot_env),20m(nand_fit);spi0.0:1m(uboot),5m(kernel),1m(dtb),9m(file_system)"
36 # CONFIG_USE_BOOTCOMMAND is not set
37 CONFIG_MISC_INIT_R=y
38 CONFIG_SPL_FSL_PBL=y
39 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
40 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xf0
41 CONFIG_SPL_ENV_SUPPORT=y
42 CONFIG_SPL_I2C=y
43 CONFIG_SPL_MPC8XXX_INIT_DDR=y
44 CONFIG_SPL_NAND_SUPPORT=y
45 CONFIG_SPL_WATCHDOG=y
46 CONFIG_CMD_BOOTZ=y
47 CONFIG_CMD_IMLS=y
48 CONFIG_CMD_GREPENV=y
49 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
50 CONFIG_CMD_MEMINFO=y
51 CONFIG_CMD_MEMTEST=y
52 CONFIG_CMD_GPIO=y
53 CONFIG_CMD_GPT=y
54 CONFIG_CMD_I2C=y
55 CONFIG_CMD_MMC=y
56 CONFIG_CMD_NAND=y
57 CONFIG_CMD_USB=y
58 CONFIG_CMD_CACHE=y
59 CONFIG_MP=y
60 CONFIG_MTDPARTS_DEFAULT="mtdparts=60000000.nor:2m@0x100000(nor_bank0_uboot),40m@0x1100000(nor_bank0_fit),7m(nor_bank0_user),2m@0x4100000(nor_bank4_uboot),40m@0x5100000(nor_bank4_fit),-(nor_bank4_user);7e800000.flash:1m(nand_uboot),1m(nand_uboot_env),20m(nand_fit);spi0.0:1m(uboot),5m(kernel),1m(dtb),9m(file_system)"
61 # CONFIG_SPL_EFI_PARTITION is not set
62 CONFIG_OF_CONTROL=y
63 CONFIG_ENV_OVERWRITE=y
64 CONFIG_ENV_IS_IN_NAND=y
65 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
66 CONFIG_DM=y
67 CONFIG_SATA_CEVA=y
68 CONFIG_FSL_CAAM=y
69 CONFIG_DYNAMIC_DDR_CLK_FREQ=y
70 CONFIG_DDR_ECC=y
71 CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
72 CONFIG_DM_I2C=y
73 CONFIG_SPL_SYS_I2C_LEGACY=y
74 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
75 CONFIG_SYS_I2C_EEPROM_ADDR=0x57
76 CONFIG_FSL_ESDHC=y
77 CONFIG_MTD=y
78 CONFIG_MTD_NOR_FLASH=y
79 CONFIG_FLASH_CFI_DRIVER=y
80 CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
81 CONFIG_SYS_FLASH_CFI=y
82 CONFIG_NAND_FSL_IFC=y
83 CONFIG_SYS_NAND_ONFI_DETECTION=y
84 CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y
85 CONFIG_SYS_NAND_U_BOOT_OFFS=0x20000
86 CONFIG_SF_DEFAULT_BUS=1
87 CONFIG_PHYLIB=y
88 CONFIG_PHYLIB_10G=y
89 CONFIG_PHY_REALTEK=y
90 CONFIG_PHY_VITESSE=y
91 CONFIG_E1000=y
92 CONFIG_FMAN_ENET=y
93 CONFIG_SYS_FMAN_FW_ADDR=0x900000
94 CONFIG_NVME=y
95 CONFIG_PCI=y
96 CONFIG_DM_PCI_COMPAT=y
97 CONFIG_PCIE_LAYERSCAPE_RC=y
98 CONFIG_SYS_QE_FMAN_FW_IN_NAND=y
99 CONFIG_DM_SCSI=y
100 CONFIG_SYS_NS16550=y
101 CONFIG_SPI=y
102 CONFIG_DM_SPI=y
103 CONFIG_USB=y
104 CONFIG_USB_XHCI_HCD=y
105 CONFIG_USB_XHCI_DWC3=y