arm: ti: k3: Resync dts files and bindings with Linux Kernel v5.14
[platform/kernel/u-boot.git] / configs / ls1021aqds_nand_defconfig
1 CONFIG_ARM=y
2 CONFIG_SKIP_LOWLEVEL_INIT=y
3 CONFIG_SPL_SKIP_LOWLEVEL_INIT=y
4 CONFIG_TARGET_LS1021AQDS=y
5 CONFIG_SYS_TEXT_BASE=0x82000000
6 CONFIG_SPL_LIBCOMMON_SUPPORT=y
7 CONFIG_SPL_LIBGENERIC_SUPPORT=y
8 CONFIG_NR_DRAM_BANKS=1
9 CONFIG_SYS_MEMTEST_START=0x80000000
10 CONFIG_SYS_MEMTEST_END=0x9fffffff
11 CONFIG_ENV_SIZE=0x2000
12 CONFIG_ENV_OFFSET=0x140000
13 CONFIG_SYS_I2C_MXC_I2C1=y
14 CONFIG_SYS_I2C_MXC_I2C2=y
15 CONFIG_SYS_I2C_MXC_I2C3=y
16 CONFIG_SYS_MALLOC_LEN=0x1002000
17 CONFIG_DM_GPIO=y
18 CONFIG_DEFAULT_DEVICE_TREE="ls1021a-qds-duart"
19 CONFIG_SPL_TEXT_BASE=0x10000000
20 CONFIG_FSL_USE_PCA9547_MUX=y
21 CONFIG_SPL_SERIAL=y
22 CONFIG_SPL_DRIVERS_MISC=y
23 CONFIG_SPL=y
24 CONFIG_AHCI=y
25 CONFIG_SYS_LOAD_ADDR=0x82000000
26 CONFIG_FIT=y
27 CONFIG_FIT_VERBOSE=y
28 CONFIG_OF_BOARD_SETUP=y
29 CONFIG_OF_STDOUT_VIA_ALIAS=y
30 CONFIG_SYS_EXTRA_OPTIONS="NAND_BOOT"
31 CONFIG_RAMBOOT_PBL=y
32 CONFIG_SYS_FSL_PBL_PBI="board/freescale/ls1021aqds/ls102xa_pbi.cfg"
33 CONFIG_SYS_FSL_PBL_RCW="board/freescale/ls1021aqds/ls102xa_rcw_nand.cfg"
34 CONFIG_NAND_BOOT=y
35 CONFIG_BOOTDELAY=3
36 CONFIG_SILENT_CONSOLE=y
37 CONFIG_SYS_CONSOLE_IS_IN_ENV=y
38 CONFIG_MISC_INIT_R=y
39 CONFIG_ID_EEPROM=y
40 CONFIG_SPL_FSL_PBL=y
41 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
42 CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xe8
43 CONFIG_SPL_ENV_SUPPORT=y
44 CONFIG_SPL_I2C=y
45 CONFIG_SPL_MPC8XXX_INIT_DDR=y
46 CONFIG_SPL_NAND_SUPPORT=y
47 CONFIG_SPL_WATCHDOG=y
48 CONFIG_HUSH_PARSER=y
49 CONFIG_CMD_BOOTZ=y
50 CONFIG_CMD_IMLS=y
51 CONFIG_CMD_GREPENV=y
52 CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
53 CONFIG_CMD_MEMINFO=y
54 CONFIG_CMD_MEMTEST=y
55 CONFIG_CMD_GPIO=y
56 CONFIG_CMD_GPT=y
57 CONFIG_CMD_I2C=y
58 CONFIG_CMD_MMC=y
59 CONFIG_CMD_NAND=y
60 CONFIG_CMD_USB=y
61 # CONFIG_CMD_SETEXPR is not set
62 CONFIG_CMD_DHCP=y
63 CONFIG_CMD_MII=y
64 CONFIG_CMD_PING=y
65 CONFIG_CMD_EXT2=y
66 CONFIG_CMD_FAT=y
67 # CONFIG_SPL_EFI_PARTITION is not set
68 CONFIG_OF_CONTROL=y
69 CONFIG_ENV_OVERWRITE=y
70 CONFIG_ENV_IS_IN_NAND=y
71 CONFIG_SYS_RELOC_GD_ENV_ADDR=y
72 CONFIG_DM=y
73 CONFIG_SATA_CEVA=y
74 CONFIG_FSL_CAAM=y
75 CONFIG_DYNAMIC_DDR_CLK_FREQ=y
76 CONFIG_SYS_FSL_DDR3=y
77 CONFIG_DDR_ECC=y
78 CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
79 CONFIG_DM_I2C=y
80 CONFIG_SPL_SYS_I2C_LEGACY=y
81 CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
82 CONFIG_SYS_I2C_EEPROM_ADDR=0x57
83 CONFIG_FSL_ESDHC=y
84 CONFIG_MTD=y
85 CONFIG_MTD_NOR_FLASH=y
86 CONFIG_FLASH_CFI_DRIVER=y
87 CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
88 CONFIG_SYS_FLASH_CFI=y
89 CONFIG_PHY_REALTEK=y
90 CONFIG_PHY_GIGE=y
91 CONFIG_E1000=y
92 CONFIG_MII=y
93 CONFIG_TSEC_ENET=y
94 CONFIG_NVME=y
95 CONFIG_PCI=y
96 CONFIG_DM_PCI_COMPAT=y
97 CONFIG_PCIE_LAYERSCAPE_RC=y
98 CONFIG_DM_SCSI=y
99 CONFIG_SYS_NS16550=y
100 CONFIG_USB=y
101 CONFIG_USB_XHCI_HCD=y
102 CONFIG_USB_XHCI_DWC3=y
103 CONFIG_USB_STORAGE=y