usb: phy: ti: Remove non-DM PHY code
[platform/kernel/u-boot.git] / configs / MSI_Primo81_defconfig
1 CONFIG_ARM=y
2 CONFIG_ARCH_SUNXI=y
3 CONFIG_DEFAULT_DEVICE_TREE="sun6i-a31s-primo81"
4 CONFIG_SPL=y
5 CONFIG_MACH_SUN6I=y
6 CONFIG_DRAM_CLK=360
7 CONFIG_DRAM_ZQ=122
8 CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
9 CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
10 CONFIG_AXP_GPIO=y
11 CONFIG_VIDEO_LCD_MODE="x:768,y:1024,depth:18,pclk_khz:66000,le:56,ri:60,up:30,lo:36,hs:64,vs:50,sync:3,vmode:0"
12 CONFIG_VIDEO_LCD_BL_EN="PA25"
13 CONFIG_VIDEO_LCD_BL_PWM="PH13"
14 CONFIG_VIDEO_LCD_PANEL_MIPI_4_LANE_513_MBPS_VIA_SSD2828=y
15 # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
16 CONFIG_AXP_DLDO1_VOLT=3300
17 # CONFIG_REQUIRE_SERIAL_CONSOLE is not set
18 CONFIG_USB_MUSB_HOST=y
19 CONFIG_VIDEO_LCD_SSD2828_TX_CLK=27
20 CONFIG_VIDEO_LCD_SSD2828_RESET="PA26"
21 CONFIG_VIDEO_LCD_SPI_CS="PH9"
22 CONFIG_VIDEO_LCD_SPI_SCLK="PH10"
23 CONFIG_VIDEO_LCD_SPI_MOSI="PH11"
24 CONFIG_VIDEO_LCD_SPI_MISO="PH12"