arch/x86/cpu/quark/quark.c

   1 /*
   2  * Copyright (C) 2015, Bin Meng <bmeng.cn@gmail.com>
   3  *
   4  * SPDX-License-Identifier:     GPL-2.0+
   5  */
   6
   7 #include <common.h>
   8 #include <mmc.h>
   9 #include <netdev.h>
  10 #include <phy.h>
  11 #include <asm/io.h>
  12 #include <asm/pci.h>
  13 #include <asm/post.h>
  14 #include <asm/processor.h>
  15 #include <asm/arch/device.h>
  16 #include <asm/arch/msg_port.h>
  17 #include <asm/arch/quark.h>
  18
  19 static struct pci_device_id mmc_supported[] = {
  20         { PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_QRK_SDIO },
  21 };
  22
  23 /*
  24  * TODO:
  25  *
  26  * This whole routine should be removed until we fully convert the ICH SPI
  27  * driver to DM and make use of DT to pass the bios control register offset
  28  */
  29 static void unprotect_spi_flash(void)
  30 {
  31         u32 bc;
  32
  33         bc = x86_pci_read_config32(QUARK_LEGACY_BRIDGE, 0xd8);
  34         bc |= 0x1;      /* unprotect the flash */
  35         x86_pci_write_config32(QUARK_LEGACY_BRIDGE, 0xd8, bc);
  36 }
  37
  38 static void quark_setup_bars(void)
  39 {
  40         /* GPIO - D31:F0:R44h */
  41         pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_GBA,
  42                                CONFIG_GPIO_BASE | IO_BAR_EN);
  43
  44         /* ACPI PM1 Block - D31:F0:R48h */
  45         pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_PM1BLK,
  46                                CONFIG_ACPI_PM1_BASE | IO_BAR_EN);
  47
  48         /* GPE0 - D31:F0:R4Ch */
  49         pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_GPE0BLK,
  50                                CONFIG_ACPI_GPE0_BASE | IO_BAR_EN);
  51
  52         /* WDT - D31:F0:R84h */
  53         pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_WDTBA,
  54                                CONFIG_WDT_BASE | IO_BAR_EN);
  55
  56         /* RCBA - D31:F0:RF0h */
  57         pci_write_config_dword(QUARK_LEGACY_BRIDGE, LB_RCBA,
  58                                CONFIG_RCBA_BASE | MEM_BAR_EN);
  59
  60         /* ACPI P Block - Msg Port 04:R70h */
  61         msg_port_write(MSG_PORT_RMU, PBLK_BA,
  62                        CONFIG_ACPI_PBLK_BASE | IO_BAR_EN);
  63
  64         /* SPI DMA - Msg Port 04:R7Ah */
  65         msg_port_write(MSG_PORT_RMU, SPI_DMA_BA,
  66                        CONFIG_SPI_DMA_BASE | IO_BAR_EN);
  67
  68         /* PCIe ECAM */
  69         msg_port_write(MSG_PORT_MEM_ARBITER, AEC_CTRL,
  70                        CONFIG_PCIE_ECAM_BASE | MEM_BAR_EN);
  71         msg_port_write(MSG_PORT_HOST_BRIDGE, HEC_REG,
  72                        CONFIG_PCIE_ECAM_BASE | MEM_BAR_EN);
  73 }
  74
  75 static void quark_enable_legacy_seg(void)
  76 {
  77         u32 hmisc2;
  78
  79         hmisc2 = msg_port_read(MSG_PORT_HOST_BRIDGE, HMISC2);
  80         hmisc2 |= (HMISC2_SEGE | HMISC2_SEGF | HMISC2_SEGAB);
  81         msg_port_write(MSG_PORT_HOST_BRIDGE, HMISC2, hmisc2);
  82 }
  83
  84 int arch_cpu_init(void)
  85 {
  86         struct pci_controller *hose;
  87         int ret;
  88
  89         post_code(POST_CPU_INIT);
  90 #ifdef CONFIG_SYS_X86_TSC_TIMER
  91         timer_set_base(rdtsc());
  92 #endif
  93
  94         ret = x86_cpu_init_f();
  95         if (ret)
  96                 return ret;
  97
  98         ret = pci_early_init_hose(&hose);
  99         if (ret)
 100                 return ret;
 101
 102         /*
 103          * Quark SoC has some non-standard BARs (excluding PCI standard BARs)
 104          * which need be initialized with suggested values
 105          */
 106         quark_setup_bars();
 107
 108         /* Turn on legacy segments (A/B/E/F) decode to system RAM */
 109         quark_enable_legacy_seg();
 110
 111         unprotect_spi_flash();
 112
 113         return 0;
 114 }
 115
 116 int print_cpuinfo(void)
 117 {
 118         post_code(POST_CPU_INFO);
 119         return default_print_cpuinfo();
 120 }
 121
 122 void reset_cpu(ulong addr)
 123 {
 124         /* cold reset */
 125         x86_full_reset();
 126 }
 127
 128 int cpu_mmc_init(bd_t *bis)
 129 {
 130         return pci_mmc_init("Quark SDHCI", mmc_supported,
 131                             ARRAY_SIZE(mmc_supported));
 132 }
 133
 134 int cpu_eth_init(bd_t *bis)
 135 {
 136         u32 base;
 137         int ret0, ret1;
 138
 139         pci_read_config_dword(QUARK_EMAC0, PCI_BASE_ADDRESS_0, &base);
 140         ret0 = designware_initialize(base, PHY_INTERFACE_MODE_RMII);
 141
 142         pci_read_config_dword(QUARK_EMAC1, PCI_BASE_ADDRESS_0, &base);
 143         ret1 = designware_initialize(base, PHY_INTERFACE_MODE_RMII);
 144
 145         if (ret0 < 0 && ret1 < 0)
 146                 return -1;
 147         else
 148                 return 0;
 149 }