10 prompt "UniPhier SoC select"
11 default ARCH_UNIPHIER_PH1_PRO4
13 config ARCH_UNIPHIER_PH1_SLD3
17 config ARCH_UNIPHIER_PH1_LD4
20 config ARCH_UNIPHIER_PH1_PRO4
24 config ARCH_UNIPHIER_PH1_SLD8
29 config MICRO_SUPPORT_CARD
30 bool "Use Micro Support Card"
32 This option provides support for the expansion board, available
33 on some UniPhier reference boards.
35 Say Y to use the on-board UART, Ether, LED devices.
38 bool "Enable boot mode pins monitor command"
41 The command "pinmon" shows the state of the boot mode pins.
42 The boot mode pins are latched when the system reset is deasserted
43 and determine which device the system should load a boot image from.
45 config CMD_DDRPHY_DUMP
46 bool "Enable dump command of DDR PHY parameters"
48 The command "ddrphy" shows the resulting parameters of DDR PHY
49 training; it is useful for the evaluation of DDR PHY training.
52 prompt "DDR3 Frequency select"
56 depends on ARCH_UNIPHIER_PH1_SLD3 || ARCH_UNIPHIER_PH1_LD4 || ARCH_UNIPHIER_PH1_PRO4
60 depends on ARCH_UNIPHIER_PH1_SLD3 || ARCH_UNIPHIER_PH1_LD4 || ARCH_UNIPHIER_PH1_SLD8
66 default 1333 if DDR_FREQ_1333
67 default 1600 if DDR_FREQ_1600