7 select SPL_DM_SEQ_ALIAS
8 select SPL_DRIVERS_MISC_SUPPORT
10 select SPL_GPIO_SUPPORT
11 select SPL_LIBCOMMON_SUPPORT
12 select SPL_LIBGENERIC_SUPPORT
14 select SPL_OF_TRANSLATE
18 select SPL_SERIAL_SUPPORT
20 select SPL_WATCHDOG_SUPPORT
21 imply BOOTSTAGE_STASH if SPL_BOOTSTAGE
22 imply SPL_BOOTSTAGE if BOOTSTAGE
23 imply SPL_DISPLAY_PRINT
24 imply SPL_LIBDISK_SUPPORT
35 config TARGET_STM32MP1
36 bool "Support stm32mp1xx"
37 select ARCH_SUPPORT_PSCI if !STM32MP1_TRUSTED
39 select CPU_V7_HAS_NONSEC if !STM32MP1_TRUSTED
40 select CPU_V7_HAS_VIRT
49 imply SYSRESET_PSCI if STM32MP1_TRUSTED
50 imply SYSRESET_SYSCON if !STM32MP1_TRUSTED
52 target STMicroelectronics SOC STM32MP1 family
53 STM32MP157, STM32MP153 or STM32MP151
54 STMicroelectronics MPU with core ARMv7
55 dual core A7 for STM32MP157/3, monocore for STM32MP151
57 config STM32MP1_TRUSTED
58 bool "Support trusted boot with TF-A"
62 Say Y here to enable boot with TF-A
63 Trusted boot chain is :
64 BootRom => TF-A.stm32 (clock & DDR) => U-Boot.stm32
65 TF-A monitor provides proprietary smc to manage secure devices
68 prompt "U-Boot base address"
71 configure the U-Boot base address
72 when DDR driver is used:
73 DDR + 1MB (0xC0100000)
78 config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_MMC2
79 hex "Partition on MMC2 to use to load U-Boot from"
80 depends on SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
83 Partition on the second MMC to load U-Boot from when the MMC is being
86 config BOOTSTAGE_STASH_ADDR
90 config SYS_BOOTCOUNT_SINGLEWORD
93 # TAMP_BOOTCOUNT = TAMP_BACKUP_REGISTER(21)
94 config SYS_BOOTCOUNT_ADDR
100 config DEBUG_UART_BOARD_INIT
103 # debug on UART4 by default
104 config DEBUG_UART_BASE
107 # clock source is HSI on reset
108 config DEBUG_UART_CLOCK
112 source "board/st/stm32mp1/Kconfig"