7 select SPL_DM_SEQ_ALIAS
8 select SPL_DRIVERS_MISC_SUPPORT
10 select SPL_GPIO_SUPPORT
11 select SPL_LIBCOMMON_SUPPORT
12 select SPL_LIBGENERIC_SUPPORT
14 select SPL_OF_TRANSLATE
18 select SPL_SERIAL_SUPPORT
20 select SPL_DRIVERS_MISC_SUPPORT
21 imply SPL_LIBDISK_SUPPORT
26 config TARGET_STM32MP1
27 bool "Support stm32mp1xx"
28 select ARCH_SUPPORT_PSCI if !STM32MP1_TRUSTED
30 select CPU_V7_HAS_NONSEC if !STM32MP1_TRUSTED
31 select CPU_V7_HAS_VIRT
36 imply SYSRESET_PSCI if STM32MP1_TRUSTED
37 imply SYSRESET_SYSCON if !STM32MP1_TRUSTED
39 target STMicroelectronics SOC STM32MP1 family
40 STMicroelectronics MPU with core ARMv7
42 config STM32MP1_TRUSTED
43 bool "Support trusted boot with TF-A"
47 Say Y here to enable boot with TF-A
48 Trusted boot chain is :
49 BootRom => TF-A.stm32 (clock & DDR) => U-Boot.stm32
50 TF-A monitor provides proprietary smc to manage secure devices
53 prompt "U-Boot base address"
56 configure the U-Boot base address
57 when DDR driver is used:
58 DDR + 1MB (0xC0100000)
60 config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_MMC2
61 hex "Partition on MMC2 to use to load U-Boot from"
62 depends on SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
65 Partition on the second MMC to load U-Boot from when the MMC is being
68 source "board/st/stm32mp1/Kconfig"
70 # currently activated for debug / should be deactivated for real product
73 config DEBUG_UART_BOARD_INIT
76 # debug on UART4 by default
77 config DEBUG_UART_BASE
80 # clock source is HSI on reset
81 config DEBUG_UART_CLOCK