6 This target config option used for below listed px30 boards.
9 * EVB_PX30 is an evaluation board for Rockchip PX30.
11 config TARGET_ODROID_GO2
14 config TARGET_PX30_CORE
15 bool "Engicam PX30.Core"
18 * PX30.Core is an EDIMM SOM based on Rockchip PX30 from Engicam.
19 * EDIMM2.2 is a Form Factor Capacitive Evaluation Board from Engicam.
20 * PX30.Core needs to mount on top of EDIMM2.2 for creating complete
21 PX30.Core EDIMM2.2 Starter Kit.
24 * PX30.Core is an EDIMM SOM based on Rockchip PX30 from Engicam.
25 * CTOUCH2.0 is a general purpose Carrier board with capacitive
26 touch interface support.
27 * PX30.Core needs to mount on top of CTOUCH2.0 for creating complete
28 PX30.Core C.TOUCH Carrier board.
30 PX30.Core CTOUCH2-OF10:
31 * PX30.Core is an EDIMM SOM based on Rockchip PX30 from Engicam.
32 * CTOUCH2.0 is a general purpose Carrier board with capacitive
33 touch interface support.
34 * 10.1" OF is a capacitive touch 10.1" Open Frame panel solutions.
35 * PX30.Core needs to mount on top of C.TOUCH 2.0 carrier with pluged
36 10.1" OF for creating complete PX30.Core C.TOUCH 2.0 10.1" Open Frame.
38 config ROCKCHIP_BOOT_MODE_REG
44 config SYS_MALLOC_F_LEN
51 default "arch/arm/mach-rockchip/u-boot-tpl-v8.lds"
62 config DEBUG_UART_CHANNEL
63 int "Mux channel to use for debug UART2/UART3"
64 depends on DEBUG_UART_BOARD_INIT
67 UART2 and UART3 can use two different set of pins to route the output.
68 For using the UART for early debugging the route to use needs
69 to be declared (0 or 1).
71 source "board/engicam/px30_core/Kconfig"
72 source "board/hardkernel/odroid_go2/Kconfig"
73 source "board/rockchip/evb_px30/Kconfig"