1 HOW TO SETUP ST-Ericsson STA2500D Bluetooth device
\r
2 ==================================================
\r
4 The Bluetooth device STA2500D is connected on the MSP port 3 of the ConneXt IO-Hub.
\r
6 Two files are released with this package which can be downloaded to the STLC2500 chip.
\r
7 \95 STLC2500_R5_03_A17.PTC patch File: it is a binary file containing a header part and the actual patches.
\r
8 This is an AXF image built in a similar way as the STLC2500 FW.
\r
9 \95 STLC2500_R5_03_03_masterpcm_clkinvert.ssf: it contains product & application specific parameters
\r
10 (values are defined by the customer) , as well as system parameters (for optimal BB/RF functionality).
\r
11 These settings are valid for all STLC2500 chips. The file is typically stored in the Host file system
\r
17 1. Copy the BT static setting file STLC2500_R5_03_03_masterpcm_clkinvert.ssf into the /lib/firmware folder
\r
18 2. Copy the BT firmware patch STLC2500_R5_03_A17.ptc into the /lib/firmware folder
\r
19 3. load the hci_uart driver:
\r
21 4. execute the hciattach command:
\r
22 # hciattach /dev/ttyAM0 stlc2500 115200
\r
24 STLC2500 R5.3 05102007 08:20:56 ZAV100131 HW Id= 0xF1
\r
25 Loading file /lib/firmware/STLC2500_R5_03_A17.ptc
\r
26 Loading file /lib/firmware/STLC2500_R5_03_03_masterpcm_clkinvert.ssf
\r
27 Device setup complete
\r
29 4. execute the hci_reset command:
\r
30 # hcitool -i hci0 cmd 01 03 0c 00
\r
32 < HCI Command: ogf 0x01, ocf 0x0003, plen 2
\r
34 > HCI Event: 0x0e plen 4
\r
37 6. enable it with hciconfig:
\r
39 [root@stuser-desktop stuser]# hciconfig hci0 up
\r
40 [root@stuser-desktop stuser]# hciconfig
\r
42 BD Address: 00:80:E1:00:AB:BA ACL MTU: 1021:4 SCO MTU: 64:255
\r
44 RX bytes:1034 acl:0 sco:0 events:33 errors:0
\r
45 TX bytes:1380 acl:0 sco:0 commands:33 errors:0
\r
47 921600 Baudrate configuration
\r
48 =============================
\r
50 replace step 4. with the two following commands:
\r
51 #hciattach /dev/ttyAM0 -s 115200 stlc2500 921600 flow
\r
52 #hcitool -i hci0 cmd 3f fc 01 14
\r